What is the best way to clean cheese equipment?

Rinse, wash, rinse, sanitize, dry

FOND DU LAC, Wisconsin — The best way to clean cheese equipment follows a fixed order: rinse off the milk solids, wash with the right detergent, rinse again, and sanitize just before the next use. Skipping or reversing steps wastes chemicals and leaves soil behind. Cheese is high in protein and fat, and those two stick to surfaces and feed bacteria if left alone.

Rinse first, and use the right water

Right after the make, rinse vats, molds, harps and tables with cool or lukewarm water to flush away curd and whey. Hot water at this stage cooks protein onto stainless steel and makes it harder to remove. Scrape off bits of curd before rinsing. Do it promptly, since dried cheese soil is harder to clean than wet.

Wash with detergent

Use a detergent made for dairy, mixed per the label, at the temperature the maker states. An alkaline cleaner removes fat and protein. Scrub with brushes made for food contact, not household sponges. Reach seams, corners, valves and underneath edges, because those spots hold soil. Use clean tools that are color-coded or reserved for this job. Give the detergent the contact time the label states.

Rinse and acid wash as needed

Rinse thoroughly with clean water after washing to remove detergent. Periodically, usually on a schedule your chemical supplier recommends, use an acid cleaner to remove mineral films, such as milkstone or hard water scale. Minerals build up over time and shelter bacteria. Never mix chemicals. Chlorine and acid together release toxic gas. Read labels and keep safety data sheets handy. The OSHA agriculture page covers chemical safety basics.

Sanitize before use

Sanitizing reduces microbes on a clean surface. It does not clean a dirty one. Use a sanitizer approved for food contact, at the strength on the label, with the contact time listed. Test the strength with strips. The EPA pesticide page explains how sanitizers are regulated. Apply sanitizer right before use, not at the end of the day, since bacteria can regrow on damp surfaces overnight.

Dry and store

Let equipment air dry on racks, off the floor. Stack nothing wet. Keep brushes and cloths clean, and replace them often. Hang harps and knives rather than stacking them.

Write it down

  1. Post the cleaning steps at the sink.
  2. Record who cleaned what, when and how.
  3. Check by eye, touch and, if you can, by an ATP swab test or a lab swab.
  4. Review the records weekly.

Get the details for your plant

Your state dairy regulator and your chemical supplier can give schedules and concentrations. The FSIS gives sanitation guidance, and eXtension offers dairy plant sanitation resources.

Special cases in cheese plants

Brine, whey and curd stick to surfaces in different ways. Brine leaves salt that corrodes if not rinsed. Whey leaves a sugary film that feeds microbes. Curd bits hide in seams and perforated molds. Soak perforated molds and small parts in detergent to loosen soil, then scrub every hole. Take apart anything with removable parts, such as valves, gaskets and agitator shafts, and clean each piece.

Watch the drains and floors

Floors and drains are a main source of contamination in a cheese plant. Keep floors dry between uses, scrub drains with a brush and detergent, and sanitize them. Keep hoses off the floor, and don't spray water in a way that splashes drain contents onto clean equipment. This matters most near finished product and in aging rooms.

Check that it worked

Cleaning looks right until you check. Run a clean white paper towel over a surface and look for residue. Smell the equipment. Use ATP swabs if your plant has them, or send swabs to a lab on a schedule your regulator suggests. If results are poor, change one variable at a time, such as detergent concentration, contact time or scrubbing, and test again. Log each change so you know what worked.

A clean plant is built on dull routines done the same way every day.