What is the best way to sample milk?

Clean hands, a mixed tank, a cold sample

CORTLAND, New York — The best way to sample milk is to take a sample that truly represents what's in the tank or cow, using clean tools, then chill it right away and label it. The test can only be as good as the sample. A perfectly calibrated analyzer reading a poorly mixed sample is just a fast way to get the wrong answer.

How you sample depends on whether you're testing a bulk tank, an individual cow, or a quarter.

Bulk tank samples

Agitate the tank for the time your buyer or the sampling procedure calls for before you draw anything. Fat rises, and a short stir gives you a sample richer or leaner than the load. Use a sanitized dipper or a sample tube that is only used for milk, never the same one that has been in a bucket of calf milk replacer. Fill the vial to the line your lab specifies, leaving headspace if the lab asks for it. Cap it, label it and get it into a cooler with ice or cold packs straight away. Milk that sits in a warm truck cab while you finish chores is no longer the same milk.

Individual cow samples

For herd testing or component checks, collect a sample from the milk meter after the cow's complete milking so it includes the foremilk, midstream and strip. Fat content changes through the milking, and partial samples distort results. Use the sample jars from your testing service, and follow their instructions on preservatives. Some labs include a preservative tablet in the vial. Don't toss it, don't double it, and mix gently as directed.

Quarter and mastitis samples

If you plan to culture for mastitis, sample before treatment. Wash and dry the teat, discard the first few streams, then scrub the teat end with alcohol. Hold the vial at an angle and collect the milk without touching the rim to the teat or your fingers. The National Mastitis Council publishes sampling procedures that walk through teat-end preparation in detail. Freeze the culture sample if you can't get it to a lab the same day and your lab approves freezing. Always ask your lab first.

Keep the chain tidy

  1. Label each vial with cow or tank ID, date and time of collection in the field, not afterward from memory.
  2. Keep samples cold and out of sunlight.
  3. Ship or deliver them promptly using the lab's packing instructions.
  4. Keep a log of what you sent.

That log matters when a result looks strange. You can check whether the sample came from the right cow, whether it sat out, and whether it was taken before or after treatment.

Check your sampling, not just your results

Once in a while, have someone watch you take a sample, or split a tank sample into two vials and send both to the lab. If the numbers differ much, your technique is probably the reason. Your buyer's field rep and your state extension dairy staff can show you proper practice. The eXtension dairy pages cover sampling basics, and your state regulatory office can tell you how official samples must be drawn for Grade A requirements.

Avoid the common mistakes

A few errors show up again and again. Samples taken from the first few inches of a tank right after filling don't match the rest. Vials topped off with a different batch hide the true result. Samples left in a pocket or on a dash warm up and spoil. Reusing a dipper without sanitizing carries bacteria from one tank to the next. And mixing up labels is surprisingly easy when you sample several cows in a row, so label before you fill, not after.

If a test result comes back that makes no sense, think about the sample first. Ask whether the sample was mixed, cold, correctly labeled and delivered on time before you blame the cows or the equipment.

Sampling feels like a minor job. It decides whether the whole test means anything.