What is the best way to sample silage?

Many grabs, one honest sample

WATERLOO, Iowa — The best way to sample silage is to take many small grabs from across the face or pile, mix them thoroughly, and send a clean, cold subsample to the lab fast. Silage varies a lot from spot to spot, so a single handful from the easiest place to reach tells you very little about what cows are eating.

Do it the same way every time, so changes in the numbers reflect the silage and not your technique.

Where to sample

For a bunker or pile, sample from the face you're feeding, not the top or edges, which may have spoiled. Take grabs from several heights and across the width of a fresh face. For a bag or tube, sample from the open end after removing any exposed material. For an upright silo, sample from the unloader output or from material delivered to the mixer.

Even better, sample the feed as it goes into the mixer, since that's what the cows get.

Grabs and mixing

Take about ten to twenty small handfuls, depending on the size of the face, and place them in a clean bucket. Mix well, then fill a clean plastic bag with about a quart of the mixture. Squeeze out the air and seal it. Use a fresh bag each time.

Keep it cold, send it quickly

Silage keeps changing in the bag. Chill it right away, or freeze it if shipping will take more than a day. Ship early in the week so it won't sit in a warehouse over a weekend. Include the sample ID, the field, the cutting and the tests you want.

Timing

Sample at several points in the silage's life. Many nutritionists take a sample at harvest to get a first look, again a few weeks after fermentation is finished, and then at feed-out. Retest when you start a new bunker, move to a new face, or notice a change in cows. Rain on a pile or a change in the weather can change dry matter quickly.

Safety at the face

Never stand or work beneath the overhang of a tall silage face. Silage can slide without warning. Use a tool to pull down feed from a distance, or take samples from loose material on the floor. Refer to OSHA's agriculture resources for hazard information on silos and bunkers. Silo gas is also a danger in the first weeks after filling a tower silo, so don't enter without proper precautions.

Tests to request

Ask for the routine forage panel, plus fermentation analysis, and any special test your situation calls for. See our articles on lab tests and reading a feed analysis report.

Common mistakes

Sampling checklist

  1. Clean bucket and bags ready.
  2. Pull ten to twenty grabs across a fresh face.
  3. Mix and fill a bag, removing the air.
  4. Label with the lot, field and date in your own records.
  5. Chill or freeze, and ship promptly.
  6. Record results against the lot.

For more, see Extension.org, Penn State Extension and Iowa State's Ag Decision Maker.

Sampling takes ten minutes, and the rest of the feeding program relies on it. It's a good ten minutes.