How do I handle a failed milk test?
Hold, confirm, find the cause
CORTLAND, New York — When a milk test fails, hold the affected milk, confirm the result, notify whoever you're required to notify, and then find and fix the cause before shipping again. In that order. Don't dump anything until you know what the failure is and what your rules require, because some failures need the milk kept for investigation. And don't panic-resample until you get a pass; that shows up in the records and tends to make things worse. A failed test is information. It points at a cow, a piece of equipment, a procedure or a person, and your job is to figure out which.
Hold the product and read the report carefully
Stop shipments or sales of milk that could be affected. Read the lab report in full: which test failed, the value, the limit, the date and time of sampling and the method. Check that the sample was collected and labeled correctly. A mix-up in sample IDs happens more often than anyone likes to admit. Write down what milk was in the tank at the time, which cows contributed, and any events such as a treated cow, a wash cycle change or a power outage.
Identify the type of failure
Different failures point in different directions. A drug residue positive means a treated animal or a procedural slip. A high bacteria count points to cleaning, cooling or udder prep. A high somatic cell count points to mastitis. A temperature failure points to the cooler. A failed pasteurization test points to the heat treatment or post-process contamination. Each has its own checklist, so name the failure first, then follow its path. The National Mastitis Council has material on udder health and milk quality.
Confirm and notify
Ask the lab whether a retest or confirmatory test is available and request it on retained sample if possible. Contact your milk buyer, co-op field person, or state dairy agency as your agreement or license requires; some failures must be reported promptly. Be factual and keep it short. Ask what documents they want and what steps must be completed before you can resume. Keep a note of who you spoke with and what was said.
Investigate and fix the cause
Walk the line. Check treatment records, withdrawal times, wash cycle temperatures and detergent, sanitizer strength, gaskets and inflations, cooler performance, water quality and milking routine. Swab if needed. Test individual cows or quarters for mastitis or residues. Fix what you find and write down the fix. If you can't find the cause, bring in your veterinarian, equipment dealer or extension specialist. AABP has veterinarian resources.
Retest before shipping again
After the fix, take new samples as required and wait for clean results before returning to normal shipments. Keep the earlier failed sample in the file with the cause and corrective action, because it shows your system works.
Prevent a repeat
Add a check to your routine that would have caught this sooner, such as a daily temperature log or a pre-ship residue screen. Tell everyone who milks about what happened, without finger pointing. Next time it'll be one phone call and a short fix.