Which heaters suit milking parlors?
Safe heat for a wet room
MADISON, Wisconsin — The heaters that suit milking parlors are the ones rated for damp, dusty, corrosive agricultural spaces, controlled by a thermostat, and sized and placed so they warm people and equipment without becoming a fire risk. Parlors are wet, full of dust, chaff and ammonia, and exposed to hose spray, so a heater built for a garage or shop often fails early. Pick based on the room, the fuel you have and how much warmth you actually need, because parlors rarely need to feel like a living room.
Decide what you're heating
Be specific. Are you protecting plumbing and equipment from freezing, keeping workers comfortable, or warming the pit floor where cold feet are a morale problem? Freeze protection needs far less heat than comfort heating.
Many parlors do well with modest, targeted heat: a small unit to keep the milkhouse and pipeline area above freezing and a separate radiant source at the operator's position. Heating the whole open parlor is expensive because cows, doors and ventilation constantly dump heat.
Types to consider
Common choices include:
- Electric radiant or infrared heaters, which warm people and surfaces directly, useful at the operator's station
- Electric unit heaters with enclosed elements, good for milkhouse and equipment rooms
- Propane or natural gas unit heaters, vented or sealed combustion models, for larger heat loads where electricity is limited
- Hydronic floor or wall systems, costly to install but even and quiet
Ask your electrician or HVAC contractor which models carry ratings for agricultural or wet locations and which are made for corrosive air. Stainless or coated housings last longer than bare steel.
Safety first: moisture, dust, ventilation
Combustion heaters need proper venting and fresh air, and carbon monoxide detectors are inexpensive insurance. Never use an unvented fuel-burning heater in a closed milkhouse. Keep heaters clear of chaff, hay dust and cobwebs, which can ignite. Mount them where hose spray won't hit them and where cows can't reach.
Electrical connections in a wet parlor should be installed to code by a qualified electrician, with ground-fault protection where required. The OSHA agriculture page and the CDC NIOSH agriculture program offer general safety information on fire, electrical and air quality hazards on farms.
Size, placement and controls
Ask the contractor to calculate the heat load for your room instead of buying by guess. Oversized heaters cycle on and off and waste money, and undersized ones run forever.
Use thermostats suited to the space, and think about set points: a freeze-protection setting keeps costs low, and a warmer setting can be used only during milking. Timers or occupancy controls trim run time. Place heaters so airflow doesn't dry out or chill milking equipment or blow dust around.
Compare cost and upkeep
Weigh purchase price, installation, fuel or electricity costs and cleaning needs. Electric units are simple to install but cost more to run in many areas; fuel units may cost less to run but need venting, fuel storage and service. Local fuel and electric rates change, so check your utility or fuel supplier for current numbers instead of relying on a rule of thumb.
Your power supplier may offer efficiency programs for farm equipment, and your extension office or farmers.gov can point you to programs on energy upgrades. Finally, set a calendar reminder for fall to clean and test every heater before the first cold night. A heater that fails quietly in December is discovered by the pipes, and they're terrible at filing reports.