How do I balance energy and fiber?

Push energy without breaking the rumen

LINCOLN, Nebraska — Balancing energy and fiber is the central trade-off of dairy feeding. Cows need dense energy to make milk, mostly from starch and fat, but they also need enough fiber, in the right particle size, to keep rumen pH steady and cud chewing going. The balance point shifts with stage of lactation, forage quality and starch source. It's the reason nutritionists argue about NDF numbers over coffee.

Why the two pull against each other

Fiber takes up room in the rumen and ferments slowly. Starch ferments fast. Too much fiber limits intake and energy supply. Too little fiber and too much starch drops pH, reducing fiber-digesting bacteria and causing acidosis and milk fat depression. The goal isn't more of either, it's the right ratio with the right quality.

Raise the quality of fiber before the quantity of starch

The cheapest way to increase energy density is to feed higher-digestibility forage. If NDF digestibility goes up, the cow gets more energy from the same fiber. That's why harvest timing, cutting height and storage matter so much. Test your forages for NDF digestibility and consider it when selecting which forage goes to which pen.

Use starch carefully

Corn grain can be processed in different ways: ground, rolled, steam-flaked or high-moisture. Finer processing speeds fermentation. Corn silage kernel processing makes starch more available. Balance starch against fiber, and spread it through the day by feeding consistently, and avoid slug feeding.

Look at the starch from every source, including silage, grain and byproducts, rather than adding it up in your head. Your nutritionist's model does this sum properly.

Add fat and digestible fiber as extra energy

Rumen-inert fats can raise energy density without adding starch. Soy hulls, beet pulp and similar feeds provide digestible fiber that stands in for part of the grain. Keep total fat within safe limits, since too much, especially unsaturated, interferes with fiber digestion.

Monitor the signals

Watch intake, manure score, cud chewing, milk fat, body condition and the shaker box. A herd getting the balance right shows steady intake and 50 percent or more of cows chewing cud when resting, a commonly cited rule of thumb among nutritionists, so confirm targets with yours. Look for undigested particles in manure, and sorting at the bunk.

Tune by pen

Fresh cows need strong energy support with a rumen still adapting. High cows need more energy density, but also tight fiber control. Late-lactation cows need less. Treating all as one group means feeding some too much and others too little. Where you can, sort by milk yield and days in milk and feed to each.

Reference material is available from Iowa State's Ag Decision Maker, University of Nebraska Extension and Penn State Extension. Kansas State Research and Extension also has dairy nutrition resources.

Adjust after every forage change

Every new silage face or hay lot shifts the balance, so re-test, re-run the ration and watch the cows. Keep a notebook of what worked. A balanced ration this month is a bad ration next month if the corn silage changed and nobody noticed.