How do I inspect manure storage safely?

Look from the outside, never from inside

FOND DU LAC, Wisconsin — Most manure storage inspections can be done from the outside, from the berm, the rim, or the walkway, and that is where you should keep your boots. Enter a pit or tank only if it is truly unavoidable, and then only under a confined space entry program with trained people and rescue gear on site. If you can't say who is rescuing whom, you're not ready to go in.

An inspection checks the structure, the freeboard, the liner or walls, and the inlets and outlets. It also gives you a record that shows you were paying attention, which helps if regulators or your lender ever ask.

Before you walk the site

Check conditions first. Don't inspect right after a heavy rain on a slick earthen berm, and don't work alone. Tell someone where you are and when you'll check in. Wear footwear with grip and keep a gas monitor clipped on if you will be near covered pits, pump pits, or agitation points. Never lean over a hatch to look in; gas collects there.

Bring a notebook or phone, a probe or measuring stick marked in inches, and your storage plan with the marked maximum level.

What to look for on an earthen basin

Walk the full berm. You're looking for:

Take photos from the same spot each time so you can compare changes. Your NRCS office can tell you what design standard applies to your structure and what the inspection notes should cover.

Concrete tanks and below-barn pits

For concrete structures, look for cracking, spalling, exposed rebar, and rust staining on walls above the liquid line. Check the rim, the gates, and the fittings. Corrosion is steady work; hydrogen sulfide attacks concrete and steel above the manure surface. If you see structural damage, don't poke at it. Have a qualified engineer evaluate it.

Pipes, pumps, and gates

Look at the transfer piping, valves, and pump connections for weeps and drips. A small stain at a coupling is cheaper than a big problem. Confirm that valves open and close freely and that emergency shutoffs are marked.

Keep a record

Write down the date format your plan uses, the freeboard measurement, weather, and what you saw. Note any repairs and who made them. For extra guidance on confined spaces, see the OSHA agriculture page and the NIOSH agriculture program.

If an inspection turns up something you can't fix on your own, such as an active seep or a cracked wall, call your engineer and your state environmental agency's contact promptly. Waiting to see if it gets better is a hobby best left to sourdough starter. Many states require you to report releases within a short window, so know the rule before you need it.

A good inspection is boring. Same route, same checklist, same photos, same notes. Do it on a set schedule and after every major storm, and you will catch most problems while they're still cheap.