How do I maintain manure pumps?

Keep the pump alive between loads

SPRINGFIELD, Illinois — You maintain manure pumps by following the maker's service schedule, keeping them clean and protected from abrasion and corrosion, watching for early signs of wear, and setting up safe lockout habits before anyone touches them. Pumps push thick, gritty, sometimes gassy material day after day, so small neglected jobs turn into expensive breakdowns.

Pump type matters, whether it's a centrifugal, chopper, piston, progressive cavity, submersible or PTO-driven unit. The manual for your model comes first. These habits apply to most.

Start with the manual and a baseline

Read the manual for your exact pump: service intervals, lubrication points, seal types, torque values and wear limits. Keep a copy in the shop and write the model and serial number somewhere you can find in a hurry.

When the pump is working well, note a baseline: flow, pressure, sound, vibration and amp draw if you can read it. A change from normal is often the first warning of a worn impeller, plugged intake or failing bearing. A pump that suddenly sounds different is talking to you.

Do the routine checks

Make these checks a habit:

After a pumping job, flush the system if the manual recommends it, especially before cold weather when sitting manure can freeze or stiffen. Drain water from lines and housings that can freeze.

Fight abrasion, plugging and wear

Manure carries sand, bedding, hair, rope, stones and bits of plastic. Sand bedding is especially hard on pumps. If you use it, ask your dealer about pumps and wear parts designed for abrasive material, and plan on more frequent inspection.

Screen or break up solids before the pump when practical, keep intake screens clear, and remove foreign objects when you see them. Don't run a pump dry unless it's designed for it. Check impellers, wear plates and liners at the interval the manual suggests, and replace wear parts before they let a seal or shaft fail. Keep a stock of the usual wear parts so a Saturday breakdown doesn't wait until Monday.

Work safely around pumps and storage

Gas from stirred storage can kill. Keep people and animals out of buildings during agitation, run ventilation, and never enter a pit or tank to unclog a pump without confined-space training, gas monitoring and proper rescue equipment. CDC NIOSH agriculture and OSHA agriculture cover these hazards. AgriSafe also has farm health and safety resources.

Lock out and tag out power or disengage the PTO and shut off the tractor before checking or clearing a pump. Keep guards on. Electric pumps need proper wiring and grounding, checked by a qualified electrician.

Keep records and plan your downtime

Write down service dates, parts replaced, hours and problems. Over a few seasons the notes will show you how long wear parts last in your operation and when to replace them before they fail.

Schedule the big service for the quiet time of year, before spring and fall pumping. Test the pump with water, if the manufacturer allows it, to find leaks and noises while you still have time to fix them. And when a pump keeps failing despite good care, ask the dealer whether it's the right type for your material.

Some warning signs deserve attention right away. A drop in flow or pressure, a pump that runs hotter than usual, a new vibration, a whine from the bearings or a drip from the seal each point to a specific part. Write the symptom in your notebook with the date, then check the likely cause before running it again. Ask your dealer to explain how to read those signs on your model, and whether a shaft seal or wear plate is the usual first failure. If you run several pumps, label each one and track them separately, since the one that sits idle most of the year has its own problems, like dried seals and stuck impellers. A few minutes of attention before a job beats hours of cleanup after a failure, and nobody wants to repair a pump in the middle of a field.