How do I maintain milking equipment?

A schedule beats good intentions

TULARE, California — Maintain milking equipment by sticking to a written schedule: daily checks, weekly tasks, and a professional test at least once a year. Wear parts get replaced on the clock, not when they fail. Most milking problems that show up as high somatic cell counts, slow milkouts or sick cows trace back to something that was a little worn and a little ignored.

Write the schedule down and post it in the parlor. Equipment gets maintained when somebody's name is next to the task.

Daily checks

At every milking, look and listen. Watch the vacuum gauge for stability. Listen for air leaks and hissing. Check liners for cracks, twists or sticky film. Look at units for slipping or crawling, and look for milk in the claw that doesn't move. Check that pulsators click evenly. Watch the teat ends after milking for color changes or swelling.

Wash the system after each milking according to the manufacturer's and your dairy's procedure. The wash needs correct temperature, chemical concentration, and flow. A wash that's a little off every day builds film that no one sees until the cell count tells you.

Weekly and monthly tasks

Once a week, check the vacuum pump oil level and condition, belts, and the air filter on the regulator. Inspect the milk filter or sock, hoses, and gaskets. Look at the claw bowls, short milk tubes and shells for wear, and lubricate parts where the manufacturer says to.

Monthly, check the inline filters, the receiver jar, and the milk pump seals. Clean the pulsator air filters. Look for rubber parts that have gone hard, soft, or sticky. Keep a log of what you check and when.

Replace wear parts on a schedule

Liners and milk tubing wear out gradually and lose their ability to massage and milk gently. They harbor bacteria in cracks. Follow the manufacturer's recommendation, usually given as a number of milkings, and keep a count. Replace gaskets, O-rings, and pulsator rubber on the schedule the manufacturer sets, even if they still look fine.

Buy spares ahead of time. Having a set of liners and a few gaskets in the shop can save a milking when something fails at five in the morning.

Test the system professionally

At least once a year, have a qualified technician run a dynamic test of the milking system. That measures how the system behaves under load with real milking conditions, unlike a simple gauge check when the system is idle. The test looks at vacuum reserve, pump capacity, regulator performance, pulsation, and sometimes milk line slope and flow. Ask the technician to leave you a written report and explain what each result means.

Test again after major changes: adding units, changing pumps or liners, or rebuilding a pipeline. Cows tell you about problems first. If cows start kicking off units, have more mastitis, or take longer to milk out, call for a test sooner than you planned.

Keep records and train people

Keep a log of vacuum readings, parts replaced, test results, and repairs. Patterns show up in a log that you'd miss in memory. Make sure everyone who milks knows how to spot the signs of trouble, from a squealing unit to a swelling teat end. The National Mastitis Council publishes guidance on milking systems and mastitis control that many dairy advisors rely on.

For safety, remember that milking involves electricity, wet floors, and animals. The OSHA agriculture page and NIOSH agriculture have safety resources, and AgriSafe supports farmers' health and safety. Your equipment dealer's manual is also free and almost nobody reads it, so be the exception.

Last, match your maintenance budget to the risk. A few hundred dollars in parts and a technician visit usually costs less than treating one outbreak of mastitis. The cheapest repair is the one done on schedule.