How do I make cheese without a cheese press?

Weights, a mold and some patience

DUBUQUE, Iowa — You can make cheese without a press by choosing cheeses that don't need one, or by pressing with household weights: a perforated mold or colander, a follower that fits inside it and a stack of weights such as water-filled jugs, cans or clean stones. Many fresh and soft cheeses, including ricotta, chevre, queso fresco, cream cheese and bloomy rinds, only need gravity. Harder pressed cheeses like cheddar and gouda need steady, controlled pressure, which you can fake with a good setup.

Start with cheeses that don't need a press

Fresh cheeses drain on their own. Ladle curd into a cloth-lined colander, tie the corners and hang the bag over a bowl or sink. Soft-ripened cheeses like brie and camembert drain in molds and flip as they firm. Feta in a mold drains under its own weight. If you're new and don't want to buy equipment, begin here.

A weight-and-mold setup

For a pressed cheese, you need three things: a mold with holes for whey to escape, a follower that fits inside it, and weight. A clean food-grade container with holes drilled in the sides works as a mold, and a plastic lid or a cut piece of food-grade board can act as a follower. Stand the mold on a rack over a tray to catch whey. Add weight on top. Gallon jugs of water weigh roughly eight pounds each, so you can build up steps. A kitchen scale lets you check the weight.

Press in stages

Light pressure first is better than heavy. Many recipes begin with a small weight for a short time, then flip the cheese, re-dress the cloth and apply more. This lets whey escape gradually and prevents a sealed rind that traps moisture. Your recipe will specify pressure in pounds and time in hours. Follow it, and write down what you used.

Lever or stacking tricks

Check your cheese

After pressing, the cheese should be firm, with a smooth surface and no visible cracks. If it's crumbly or has gaps, you probably used too much pressure too early or the curd was too dry. If it's soft or weeps whey for days, you need more weight or longer pressing.

Sanitize and stay safe

Everything that touches the curd must be clean and food-grade. Avoid materials that can leach chemicals or rust. Keep the cheese cold when you can, and be careful with raw milk rules.

Learn more

Extension resources like Penn State Extension and ATTRA offer basics on cheesemaking equipment. If you intend to sell, your state agriculture department can tell you what is required, and USDA AMS covers local food marketing.

Improvised mold ideas

Many cheesemakers start with whatever is in the kitchen. Clean yogurt tubs or food-grade containers with holes poked through the sides make decent molds, and a cut-down food-grade bucket can serve for larger wheels. A pot lid or plastic disc that fits inside can serve as the follower. Sand burrs and sharp plastic edges on drilled holes so they don't tear the cloth. Keep the mold raised on a rack or upside-down plate, so whey can drain freely. Always wash and sanitize improvised molds before each batch and replace them if they crack or stain, since scratches hold bacteria.

Use gravity and time

When you lack a press, patience helps. Letting a cheese drain slowly in its mold overnight, flipped a couple of times, often does what you'd otherwise do with extra weight. Warm rooms speed drainage but also speed acid development, so keep the room moderate. If a cheese seems wetter than expected after the usual time, add weight gradually, or extend draining time and check again.

A homemade setup will work well enough to get you started. If you end up making cheese every week, a real press is a good investment.