How do I measure dry matter intake?

Weigh feed, test moisture, do the math

LUBBOCK, Texas — Dry matter intake is the pounds of feed a cow eats with the water removed. It is the number nutritionists work with, because a ration at 40 percent moisture and one at 55 percent moisture deliver very different nutrition from the same wet pounds. You measure it by weighing the feed you offer, weighing what's left, testing the moisture in both, and dividing by the cows in the pen. It takes a little discipline and a decent scale, and it's worth doing for every pen at least periodically.

Weigh what goes in

Use the scale on your mixer wagon or loader, and make sure it has been calibrated recently. Record the wet weight of the TMR or each ingredient delivered to each pen, for each feeding. If you feed more than one batch a day, add them up. For a quick herd-level estimate, you can total the load tickets or mixer records for a week, but individual pen records are better because intake varies a lot between fresh, high and late-lactation groups.

Weigh the refusals

Before the next feeding, collect leftovers from the bunk and weigh them. For a pen that's bunked on a concrete apron, a shovel and a bucket on a hanging scale work fine. Take a sample of the refusals for moisture testing, since leftover feed is often drier or wetter than what you put out. If a pen has no refusals, you can't tell if the cows could have eaten more, which is why many dairies aim for a small amount left over.

Test dry matter

Dry matter changes with every rain and every new bunker face, so measure it. Common methods include a Koster tester, a microwave with a scale, or a forced-air oven. Instructions for the microwave method are widely published by university extension programs, including Penn State Extension and University of Nebraska-Lincoln Extension. Follow the drying steps exactly and weigh in grams so small differences show up. Wet silages are the main place where bad estimates hide.

Do the arithmetic

Here is the basic calculation:

  1. Wet pounds fed times the dry matter fraction of the ration gives dry matter offered.
  2. Wet pounds refused times the dry matter fraction of the refusal gives dry matter refused.
  3. Offered minus refused gives dry matter eaten.
  4. Divide by head count in the pen, using the number that were actually there.

Take the average over several days, since one day can swing for reasons that aren't about the ration. Accurate head counts matter. A pen that changed by five cows will change the per-cow number noticeably.

Compare to a target and track the trend

Your nutritionist will usually have a predicted intake for each group based on body weight, milk and stage of lactation. Compare your measured number with that. A gap points to something to check, such as forage quality, bunk space, water, heat stress or ration sorting. Don't judge from a single day. Watch the trend, and write down the changes you made so you know what moved the number.

Individual cow intake and other tools

Measuring one cow's intake needs feed gates or electronic feeding equipment, which is mostly a research setup. Most commercial farms use pen-level measurement. Some feed software also tracks delivery and refusals for you. If you pay for a feed consultant, ask what method they use for intake and how they correct for moisture. For general dairy nutrition references, eXtension and the USDA National Agricultural Library point to university publications. A dry matter test costs a few minutes; a wrong guess can cost real milk.