How do I standardize milk for cheese?

Balance fat to protein with a simple square

GREEN BAY, Wisconsin — You standardize milk for cheese by measuring its fat (and ideally protein) and then blending in cream or skim milk until the ratio fits the cheese you want. The standard tool is the Pearson square, a simple bit of arithmetic that tells you how many parts of each ingredient to combine. Standardizing makes your cheese consistent from one batch to the next, so the milk's seasonal swings don't change your product.

Why bother

Milk changes with the season, the feed and the animals' stage of lactation. Cheese made from unadjusted milk can vary in yield, moisture and texture. Cheesemakers standardize so that the fat-to-protein ratio stays steady. The target depends on the cheese, and a good recipe or extension publication will name it. Large plants measure with instruments. Small makers can use lab results or a simple test kit.

Step one: measure

Get the fat percentage of your milk by a Babcock or Gerber test, a milk analyzer, or a dairy lab report. Measure the fat of the cream or skim you plan to use. If you also have protein figures, note those, since ratio matters. Take a well-mixed sample, because cream rises quickly in cold milk.

Step two: the Pearson square

Draw a square. Put your high-fat ingredient in the top left corner and your low-fat ingredient in the bottom left. Put your target fat in the center. Subtract diagonally, always the smaller from the larger. The results in the right corners are the parts of each ingredient.

Example: you have milk at 4.0 percent fat and skim milk at 0.1 percent, and you want 3.2 percent. Subtract 0.1 from 3.2 to get 3.1 parts milk. Subtract 3.2 from 4.0 to get 0.8 parts skim. Mix 3.1 parts milk to 0.8 parts skim. Divide by your total volume to get the amounts.

Step three: blend and recheck

Mix the milk and the added ingredient thoroughly at a cool temperature. Retest the fat if you can. Small differences in measurement can add up, so check the result before you make cheese. Record the final number in your make sheet. Over time you will see how your milk varies, and your targets will be easier to hit.

Practical tips

Where to learn more

Dairy processing courses at land-grant universities cover standardization, and Penn State Extension and University of Wisconsin farm programs are good places to look. USDA AMS and your state agriculture department can explain testing and labeling rules for sale.

Equipment for the job

Standardizing doesn't require fancy equipment. A good scale or graduated container lets you measure by volume or weight. A thermometer is needed since fat measurement depends on temperature. A cream separator lets you skim milk to a known fat level. If you don't have one, let milk sit cold overnight, skim the cream with a ladle and weigh or measure what you take. Use clean, sanitized containers, and don't forget to stir the milk well before sampling. A fat test taken from the top of an unstirred container will mislead you by a wide margin. Take samples from the middle, after mixing, every time.

When not to standardize

Not every small maker needs to. If your herd gives steady milk and your cheeses turn out consistent, adjusting may add work without much benefit. Standardizing earns its keep when seasons swing fat widely, when you blend milk from several sources or when you sell to customers who expect the same cheese every time. Start by measuring only, and adjust once you see a pattern.

A calculator does the math, but a notebook tells you what happened last month. Keep both.