How do I test corn silage starch?

Sample right, then pick the lab test

AMES, Iowa — You test corn silage starch by sending a properly collected sample to a forage testing laboratory and asking for a starch analysis, usually run by near-infrared spectroscopy or wet chemistry. The lab number is only as good as the sample, so most of the work is on your end. Starch matters because it is a major energy source in the ration, and it varies a lot from one field, hybrid and chop setting to the next. If you're formulating without a starch value, you're guessing.

Collect a sample that represents the feed

Take several handfuls from different spots across the bunker face or pile, not just the top layer or the easiest corner. Mix them in a clean bucket, then fill the sample bag, squeeze out the air, seal it and keep it cool until it ships. If you've just filled a silo, wait for fermentation to finish before relying on the numbers, because the fermented value is what the cow sees. Write down which field, hybrid and fill date the silage came from, so you can compare results later. Resample when you open a new face or switch fields.

Pick the right lab and method

Ask your nutritionist or extension office which labs they trust. Many forage labs participate in proficiency programs run through the National Forage Testing Association or similar groups, and a lab that takes part in proficiency testing is worth asking about. Near-infrared testing is fast and cheap and works well for routine starch estimates. Wet chemistry is slower and costs more, but it can settle questions when results look off. Iowa State's Ag Decision Maker and Penn State Extension cover forage testing basics.

Ask about starch digestibility, not just the percentage

Total starch percentage doesn't tell you how much the cow can use. Fermentation time, kernel hardness and how well the kernels were broken at chopping all change digestibility. Some labs offer ruminal starch digestibility tests, often reported as a percent digested after a set number of hours. Ask what your lab offers and how to read it. Your nutritionist can fold it into the ration. The Cornell Net Carbohydrate and Protein System work discussed through the Nutrient Management Conference materials is one reference for how these values are used.

Check kernel processing at the same time

Starch values won't catch whole kernels. A kernel processing score test, where you screen a sample and measure how much starch passes through different sieves, is a better window into processing quality. Some extension offices will show you how to do this, or your nutritionist may do it on farm. Pair it with a quick look at the manure: whole kernels in manure mean you're wasting starch.

How often to test

Test at harvest, after fermentation, when you open a new face or bag, and any time milk or manure changes. A single analysis can't last the whole year, since a bunker often spans several fields and conditions. Keep results in a spreadsheet so you can see the trend.

What to do with the results

  1. Share the report with your nutritionist.
  2. Compare starch and digestibility against previous years.
  3. Adjust grain or supplement if starch runs high or low.
  4. Note the field and hybrid for next year's seed decision.

A starch test costs less than a bag of mineral and can save you from feeding more grain than the cows need. Take a good sample, ship it cool, and read the whole report, not just the first number.