How do I prevent biofilm in dairy equipment?
Remove soil, break routines of neglect
STEVENS POINT, Wisconsin — You prevent biofilm in dairy equipment by removing food and moisture, cleaning thoroughly and on schedule, and fixing the places where bacteria can hide. Biofilm is a slimy layer of bacteria that sticks to surfaces and protects itself from sanitizer. Once it forms, it resists ordinary cleaning, so prevention beats cure.
Understand how it forms
Bacteria attach to surfaces, especially where milk residue, moisture and warmth are present. They multiply and produce a sticky matrix that glues them in place. Scratches, cracks, worn gaskets and rough welds give them a foothold. Over days, the layer thickens. Sanitizer applied over biofilm hits the top layer and not much below.
Clean on time, every time
Delay is the best friend of biofilm. Rinse equipment soon after milk contact, and use the full wash cycle every time. Short cuts in water temperature, detergent concentration or contact time leave residue. Follow the schedule and concentrations your chemical supplier gives. Include an acid wash regularly to remove mineral films that anchor bacteria.
Pay attention to trouble spots
- Rubber parts such as gaskets, inflations and hoses that wear, crack or swell.
- Dead ends in piping where milk sits without flow.
- Valves, gaskets and seals with crevices.
- Drains, floors and wet corners.
- Scratched or pitted surfaces on tanks and vats.
Take parts apart as the manufacturer directs and scrub them by hand. Replace worn rubber on schedule. Brushes and sponges can carry bacteria between areas, so keep them clean and replace them.
Use mechanical action and the right chemistry
Biofilm is removed by a combination of detergent, scrubbing or turbulence, temperature and time. Water velocity in a CIP system matters, as does coverage of the whole circuit. Some plants use specialized cleaners, such as enzymatic or oxidizing products, for biofilm control. Ask your chemical supplier and equipment dealer what they recommend, and check that any product used on food surfaces is approved for that purpose. The EPA pesticide page explains how sanitizers are regulated.
Verify your cleaning
Check by sight and by touch. Use ATP swab tests or lab swabs of equipment surfaces, and watch bacteria counts on milk or product. Trends matter. If counts creep up while cleaning looks fine, suspect hidden biofilm. Plants with ready-to-eat dairy products should talk to their regulator about environmental monitoring for Listeria. The FSIS offers sanitation and Listeria guidance.
Build in maintenance
Schedule time to disassemble and inspect. Fix leaks and standing water. Keep floors and drains clean. A dry plant is a hard place for bacteria to live. Train every person who cleans, and write down the steps. eXtension and the National Mastitis Council have material relating to milking system cleaning and udder health.
Watch for early warning signs
A slimy feel, a faint odor that doesn't go away after cleaning, or cloudy rinse water are all hints. So are rising bacteria counts that don't respond to your normal wash. Take them seriously. Run your finger along hidden surfaces after cleaning, such as the underside of lids and gaskets, and look at them in good light.
Respond with a reset
If you suspect a biofilm, don't just add more sanitizer. Take the system apart, replace worn parts, scrub with detergent and brushes, use the cleaners your supplier recommends for the problem, and then verify with swabs. Some plants schedule a deeper cleaning every so often as a reset. Ask your chemical supplier and regulator what makes sense in your plant. Repeat checks until results come back clean, and keep the records.
Mind the cold side too
Biofilm isn't only a hot-process problem. It forms on cold surfaces like bulk tank walls, cheese tables, brine tanks and aging room shelving. Cold slows growth but doesn't stop it, and some bacteria, including Listeria, do well in cool, damp places. Treat drains, condensate pans and wet floors in cold rooms as risk spots, and clean them as often as the hot side.
Biofilm doesn't happen overnight. It happens a little at a time while no one's looking.