How do I test sanitizer strength?
Use matched strips, fresh solution, label range
MANITOWOC, Wisconsin — You test sanitizer strength with test strips or a titration kit made for the specific chemical you're using, on a freshly mixed solution at the temperature the label states, and compare the result with the concentration range on the product label. A strip for chlorine tells you nothing about a quat, and the other way around. Matching the test to the chemical is the first rule.
Pick the right test
- Chlorine: strips that read in parts per million of chlorine, in the range listed on your product label.
- Quaternary ammonium: strips made for quats, not chlorine.
- Peracetic acid: strips made for peracetic acid, usually reading a different range.
- Acid anionic: strips or titration for that product, per the supplier.
Buy tests from your chemical supplier or a reputable lab supply source, and check the expiration date. Old strips drift.
Test correctly
- Mix sanitizer using the label ratio and the water you actually use at the sink.
- Hold the strip in solution for the time on the package. Don't swish unless it says so.
- Compare the color to the chart right away, in good light.
- Record the result.
Temperature and water pH affect both the sanitizer and the test. If the label says to use warm water, check at that temperature, not straight from a cold hose.
Test often
Test when you mix a fresh batch, and again during use, since sanitizer weakens as it meets soil and air. A sanitizer bucket that has been sitting for hours isn't the same as it was at the start. Replace it when the reading falls below the label range or the solution looks dirty. Automatic dispensers drift, too, so check them against strips regularly.
Too strong is also a problem
More isn't better. Overly strong chlorine corrodes stainless steel and rubber and may leave residues. Some labels require rinsing at high concentrations and others don't. Read your label. The EPA pesticide page explains label rules for sanitizers, and your state regulator can tell you what's allowed in your operation.
Keep records
Write down date, time, chemical, reading and initials. Inspectors often ask for logs. If readings run low, check water quality, the dispenser, product age and storage. Hard water and high pH change how chemicals behave, and your chemical supplier can test your water.
Safety
Wear gloves and eye protection when mixing, and add chemicals to water as the label says. Never mix products. Store strips dry and closed. The OSHA agriculture page provides safety guidance, and eXtension and the FSIS offer sanitation guidance for dairy operations.
Troubleshooting weak readings
If strips show a weak solution even when you mixed it right, look for the usual suspects. Water that's too hot can drive off chlorine. High pH or hard water can reduce the effect of some products. Old stock loses strength. Organic soil, such as milk film, uses up sanitizer. Dispenser tubing can clog or crack. Check each one, fix what you find, and retest.
Train and verify
Show every person who mixes sanitizer how to test it, and watch them do it once. Post the target range next to the sink. Spot-check the logs weekly and compare them to what you see on the equipment. The goal isn't paperwork for its own sake, it's catching a weak solution before it touches milk contact surfaces.
Check the dispenser too
If your plant uses an automatic dispenser, don't just trust the controller's display. Draw a sample at the point of use and test it with a strip. Check the supply line for kinks and air bubbles, and check that the product drum isn't empty. Dispensers fail quietly, and a weak solution going out for a week without anyone noticing is how problems build.
Know your contact time
Strength is half the story. Sanitizer also needs the contact time on the label, usually measured in seconds or minutes. A strong solution wiped off immediately does little. Set a timer if your crew is in a rush, and let surfaces stay wet for the whole time before use.
A strip costs pennies. A failed inspection or a spoiled batch costs a lot more.