How do I read a feed analysis report?
Start with dry matter
GREEN BAY, Wisconsin — A feed analysis report looks like a wall of abbreviations, but you can read it in a few passes: confirm the basis (as-fed or dry matter), check moisture, then protein, fiber, energy, and any special tests. Once you know what the columns mean, you can compare lots, spot problems, and talk sensibly with your nutritionist.
Start by checking whether you're reading as-fed or dry matter, because mixing them up is the most common mistake.
As-fed versus dry matter
Most reports give each value two ways. As-fed shows the numbers in the feed as it comes out of the bunker, water included. Dry matter basis shows the numbers with water removed. Rations are balanced on dry matter, so that's the column that matters for comparing feeds. Wetter feeds always look lower as-fed.
Moisture and dry matter
Dry matter percentage tells you how much of what you're hauling is actual feed. Changes in dry matter change how many pounds of as-fed feed you need to deliver the same nutrition. For silage, check dry matter often, since rain or drying can shift it quickly.
Protein
Crude protein is the standard figure. Some reports break it into soluble protein, degradable protein and protein tied up in heat damage, often shown as ADF-bound protein or ADICP. High values of that last one suggest heat damage, which lowers protein availability. Ask your nutritionist what's normal for each forage.
Fiber
NDF is the total cell wall, which fills the rumen. ADF is the less digestible portion, and it correlates with lower energy. NDFD, if reported, shows how much of the fiber is digestible. Lignin, if reported, is the indigestible part. Higher NDF generally means less intake room, and higher ADF means less energy, but digestibility sorts out how much that matters.
Energy
Reports may list net energy for lactation, total digestible nutrients, or relative feed value and relative forage quality for hay. These are calculated from other values, and labs use different equations, so compare numbers from the same lab. Don't treat a small difference in estimated energy as meaningful.
Starch, sugar and fat
Corn silage reports often include starch. Some feeds also show sugar and ether extract, which is crude fat. These help balance carbohydrates and fat in the ration.
Minerals
Calcium, phosphorus, magnesium, potassium, sodium, sulfur and chloride are typical. Potassium and sodium matter for dry cow programs, and sulfur matters when feeding byproducts. Watch the units, whether percent or parts per million.
Silage fermentation values
pH, lactic acid, acetic acid, butyric acid, ammonia and ash tell you how well silage fermented. High butyric acid or high ammonia point to poor fermentation. Ask your nutritionist to interpret, as target ranges depend on crop and moisture.
Reading routine
- Confirm the sample ID, feed type and date received are right on the report.
- Check the basis, then dry matter.
- Look at protein, fiber and digestibility.
- Review energy and starch.
- Check minerals and fermentation.
- Compare to the last lot from that field.
- Flag anything odd and call your nutritionist.
Reports vary from lab to lab, so ask your lab for a legend of abbreviations. For more help, Extension.org, Penn State Extension and Iowa State's Ag Decision Maker all publish guides on interpreting forage tests.
Numbers on the page only matter if they match what's in the bunker. If a result looks strange, resample before reformulating the ration.