How do I store milking equipment between uses?

Clean, dry, drained, covered

STILLWATER, Oklahoma — Store milking equipment clean, drained, dry and protected, and sanitize it again right before the next use. The goal between milkings is to keep milk residue, moisture and pests from turning rubber and steel into a bacteria nursery. For a quick turnaround between milkings, the routine is different from storage for a dry spell or a seasonal break, so plan for both.

Between milkings: wash first, drain well

Rinse equipment with lukewarm water right after milking, before milk dries on surfaces. Then run the hot detergent wash and acid rinse your equipment dealer or supplier recommends. The details of temperature, chemical strength and contact time are on the product label and the equipment maker's guidance, so follow those, not a neighbor's habit.

After washing, let everything drain. Hang inflations and milk tubes so they drain downward. Lay claws and hose assemblies on a rack, not on the floor. Standing water in a line invites bacteria, so slope what you can and open low-point drains. A short written wash checklist posted at the sink helps a new hire and a tired one equally.

Sanitize just before use, not just after

Many dairies sanitize equipment right before milking instead of leaving sanitizer sitting in the system for hours. Leftover sanitizer can degrade rubber and corrode certain metals. Check your chemical label and equipment manual. If the sanitizer needs a drain and rinse requirement, follow it, and be sure your buyer's rules about final rinse are met.

The National Mastitis Council offers general guidance on milking routines and equipment hygiene that pairs well with your supplier's wash instructions.

Rubber parts: store with care

Inflations, short milk tubes and gaskets are the pieces that degrade fastest. Keep them out of direct sun, away from heat, ozone sources like electric motors, and away from solvents and fuel. Many farms rotate two sets of inflations so each set rests between uses, which can extend usable life. Ask your dealer whether that makes sense for your liner type.

Don't stack heavy items on rubber, and don't leave inflations stretched or twisted. Replace them by milk-count or hours, per the manufacturer's recommendation, even if they look fine.

Longer shutdowns and seasonal breaks

If a seasonal herd dries off or a parlor will sit idle for weeks, clean thoroughly, then:

  1. Drain and dry the pipeline and bulk tank, leaving the outlet valve open and manhole slightly ajar if recommended.
  2. Remove inflations and store them clean and dry in a sealed container.
  3. Cover or close off openings to keep out insects, rodents and dust.
  4. Run vacuum pump service per the maker's schedule, including oil checks.
  5. Protect from freezing where winters bite.

Before restart, do a full wash and sanitize cycle, check vacuum level and pulsation, and test the system before cows come in. A parlor that's been idle often reveals a dead pulsator at the worst possible moment.

Pests, records and inspection

Mice love warm, quiet milkhouses and the crumbs of feed nearby. Keep feed and trash away from the equipment room, seal gaps, and put cabinets on closed doors. Flies matter too.

Keep a maintenance log noting wash times, part replacements and any odd smells or residue. If your milk quality shifts, that log is the first thing you and your dairy technician will want. For milk-quality questions tied to cleaning, your milk buyer's field staff and your state dairy regulator are good first calls, and Penn State Extension offers general dairy equipment guidance. Good storage costs minutes. Bad storage costs inflations, quality premiums and sometimes a whole load.