What humidity does cheese aging require?

Higher for soft cheese, lower for hard

TAOS, New Mexico — Most aged cheeses do best in the range of roughly 80 to 95 percent relative humidity, with the exact number depending on style. Hard, dense cheeses like cheddar and parmesan style usually sit toward the lower end of that range. Bloomy rinds and washed rinds sit toward the higher end. Too dry and the rind cracks and the cheese dries out. Too wet and slime and unwanted molds take over.

Why humidity matters

The air around the cheese pulls moisture out of the rind. If the air is too dry, the rind hardens, cracks, and the cheese loses weight, which means lost yield and a tough texture. If the air is too moist, surfaces stay wet, and slimy bacteria and unwanted molds grow. The goal is a rind that dries slowly and evenly.

Rough ranges by style

Treat these as starting points. Your recipe and supplier may suggest different numbers, and your cave's behavior will vary.

Measuring humidity

Buy a decent digital hygrometer, and check it against a salt test: a sealed container with damp table salt will settle near a known humidity. Many inexpensive hygrometers drift, so test and note the offset. Place the sensor near the cheese, not by a wall or a vent, and watch readings over days, not minutes.

Raising and lowering humidity

To raise humidity, add a tray of water, a wet towel, or a small humidifier with a controller. Keep these clean. To lower it, open the door more often, reduce water sources, or add airflow with a small fan on a timer. Don't blow air directly across the cheese.

Wrapping or bagging cheese helps in a dry space. Cheese paper and loose-fitting containers hold humidity close to the cheese while still letting it breathe.

Signs your humidity is off

  1. Cracked or leathery rind: too dry.
  2. Sticky, slippery surface: too wet.
  3. Pink, orange, or fuzzy patches that don't belong: may mean too much moisture or poor airflow.
  4. Cheese weight dropping faster than expected: dry air.

When you spot a problem, adjust slowly. Big swings stress the cheese.

Pair humidity with temperature

Temperature and humidity work together. Warmer rooms need more attention to moisture. Keep the cave in a steady cool range, and don't open the door and leave it open.

Reading the rind as a gauge

Your cheese tells you how conditions are going. A rind that dries evenly and feels firm is a good sign. Soft, sticky patches show too much moisture. Hairline cracks show it's too dry. Check a few wheels in different parts of the cave, because corners and shelves near the cooling unit can be drier than the middle.

Quick fixes for common spaces

In a dry basement, put a pan of water with a clean sponge in the cave and check the hygrometer after a day. In a damp cellar, try more airflow and shorter door-closed periods. In a refrigerator-based cave, lining the floor with a damp towel and opening the door briefly for fresh air often keeps humidity in range. Make small changes and wait a day or two before you judge the result, since humidity takes time to settle.

Salt test for your hygrometer

To check a hygrometer, seal it in a small container with a saucer of damp table salt for many hours. Read the display afterward, and compare it to the known value for salt, which sits in the mid-seventies percent. Note the difference, and apply it to future readings. Repeat every few months, since sensors drift.

Learn more

eXtension, Cornell small farms, and the University of Wisconsin farm extension site carry farmstead cheese material. Penn State Extension is another good source, and the USDA Food Safety and Inspection Service covers safety.

Humidity is the quiet variable. Get it right and the rind looks after itself. Get it wrong and the cheese has opinions.