What is the best way to add cream to cheese milk?

Cold, fresh cream, stirred in gently

LANCASTER, Pennsylvania — The best way to add cream to cheese milk is to use fresh, pasteurized cream without stabilizers, measure out the amount with a simple calculation, warm it slightly so it blends smoothly, and stir it gently into cold milk before you begin heating and culturing. Cream is what makes brie, camembert and other rich cheeses taste like themselves. Add it carelessly and you'll get fat clumps that float, lose fat in the whey and end up with greasy, uneven cheese.

Pick the right cream

Use fresh, pasteurized cream, ideally unpasteurized only if you are using raw milk under legal rules. Avoid ultra-pasteurized cream with stabilizers or gums, which can change how the curd sets. Cream typically runs about thirty to forty percent fat, but check the carton or measure it. Heavy cream from a local dairy is often a good source. Keep it cold until you use it.

Work out how much

Use the Pearson square. Say your milk is 3.5 percent fat, your cream is 36 percent and you want 5 percent. Subtract 3.5 from 5 to get 1.5 parts cream. Subtract 5 from 36 to get 31 parts milk. For ten gallons of milk, that works out to a little under half a gallon of cream. Check your numbers with your own milk and cream and recheck after mixing if you can measure fat.

Blend it in

Bring the cream to a cool room temperature so it doesn't shock the milk. Pour it in slowly while stirring gently with a clean spoon or ladle. Do this before heating, while the milk is still cold or lukewarm, so the fat disperses easily. Avoid vigorous whisking that traps air or churns the fat. If you see fat flecks or buttery bits, you've overworked it or the cream was too cold.

Handle the rich curd

Higher fat makes a more tender curd, so adjust your technique. Cut the curd more gently, stir slowly and ladle with care. Rough handling sends fat into the whey. Check the whey: if it looks cloudy and yellow, you lost fat. Some makers add extra calcium chloride to strengthen the set. Higher fat milk also holds heat differently, so watch your temperature closely.

Which cheeses benefit

Keep the legal side in mind

If you sell cream-enriched cheese, it needs accurate labeling and your state's licensing. Contact your state agriculture department, and look at USDA AMS and Penn State Extension for resources. The National Agricultural Law Center gives legal background.

A worked example for a small vat

Suppose you start with five gallons of milk at three and a half percent fat and want a rich bloomy-rind milk at about five percent. With cream at thirty-six percent, the square gives you one and a half parts cream to thirty-one parts milk. For five gallons, that is roughly a quart of cream, a little under it. Add it, stir gently, and let it settle for a few minutes before you heat. If you plan to pasteurize, add the cream first so it is treated together with the milk. Write down the amount and the resulting texture of the cheese, and adjust by small steps in later batches.

Common mistakes

Cream is the one ingredient where more is usually better, until the whey turns yellow. Watch the whey and you'll know.