What is the best way to clean a bulk tank?

Rinse, wash, rinse, sanitize, in order

HEREFORD, Texas — The best way to clean a bulk tank is a consistent sequence: rinse right after the milk is gone, wash with the right chemical at the right temperature, rinse, then sanitize just before the next milk goes in. Skip a step or cut the time, and milk film builds up where you can't see it. Bacteria love a good film.

The details depend on your tank and wash system, so start with the instructions from your tank manufacturer and your chemical supplier. What follows is the common routine.

Rinse immediately after pickup

As soon as the hauler leaves and the tank is empty, rinse the inside with lukewarm water, in the range your chemical supplier recommends. Water that is too hot can bake milk proteins onto the stainless steel, and water that is too cold leaves fat behind. Rinse until the water runs clear. This step removes most of the milk residue and makes the wash far more effective.

Do not leave an empty tank to sit with milk residue drying on the walls. It is much harder to clean the next day.

Wash with the correct chemical and temperature

Use a detergent made for dairy equipment, usually an alkaline chlorinated cleaner or an equivalent. Follow the label for concentration, water temperature and circulation time. The wash water should start hot enough, and the final water should not cool below the supplier's recommended minimum; ask your supplier for the numbers rather than trusting memory. Check water hardness, because hard water can reduce detergent effectiveness and cause scale.

Automatic washers should spray all surfaces, including the lid, agitator, and outlet. If you wash by hand, use a brush made for dairy tanks and reach every surface, including the manway gasket and the outlet valve.

Acid wash and rinse

Alkaline detergents leave mineral deposits over time, so most tanks need an acid wash on a regular schedule. Many farms use an acid rinse a few times a week. Your chemical supplier will tell you how often, and what concentration. After washing, rinse with clean water to remove the detergent.

Clean or replace seals, gaskets, and valves according to the manufacturer. Take apart the outlet valve and clean it separately on schedule. Milk can hide in the parts you don't see.

Sanitize before filling

Sanitizing happens shortly before milk goes in, not right after the wash. Use a sanitizer approved for food contact surfaces at the label concentration, and let it drain or follow the instructions. Sanitizing a dirty tank is a waste of chemical; it only works on a clean surface.

Check the tank interior in good light. Look for film, milkstone, or a cloudy appearance on the stainless steel. Run your hand over the surface, because a rough or slick patch can tell you something your eyes missed. Check the bottom and the area around the agitator shaft.

Verify, log, and troubleshoot

Record each wash: time, temperature, chemical used, and who did it. If your cell count or bacteria counts go up, the wash log is the first place to look. Your milk buyer's field person or an extension dairy specialist can help you find the problem, and the National Mastitis Council offers general milk quality information.

Common problems include low water temperature, wrong chemical concentration, worn spray ball or nozzles, and short wash times. Water flow can drop if filters clog.

For farm safety, wear splash protection and never mix chemicals; acids and chlorinated products can release dangerous gas together. OSHA's agriculture page and NIOSH are good places to read about chemical safety. Check your state dairy regulations and talk to your milk buyer about what inspectors expect. A tank that you wash the same way every time, and write down, is a tank that passes inspection without drama.