What is the best way to feed corn silage?
Consistency beats any single trick
MADISON, Wisconsin — The best way to feed corn silage is to feed it the same way every day: fresh face, a well-mixed total mixed ration, consistent dry matter, and enough long forage in the diet to keep cows chewing. Corn silage is the backbone of many dairy rations because it supplies both energy and fiber at a low cost per ton of dry matter. It's also the easiest forage to waste or mess up, since it spoils when oxygen gets in and changes in moisture show up in the bunk within days.
Manage the face like it matters
Silage heats and spoils where air gets in, so the exposed face is where most losses start. Remove a clean layer across the entire face with a facer or defacer instead of pulling chunks off the bottom, which leaves loose, aerated silage behind. Move across the face fast enough to take off a few inches per day in cool weather, and more in warm weather. If you feed less than the face needs, consider narrowing the bunker width at filling time or switching to bags. Don't feed silage that is hot, moldy or slimy; spoiled silage cuts intake and can carry mold toxins.
Know the dry matter and test it often
A TMR is built by weight, so a change in silage moisture changes the diet cows actually get. Check dry matter at least weekly, and more often after rain or when you change faces. A microwave, a Koster tester or a forced-air oven all work if you're consistent. Then adjust the amounts on the mixer sheet. University of Wisconsin Extension's dairy pages and Penn State Extension have guidance on dry matter testing and ration adjustments.
Balance the ration around it
Corn silage is high in starch and moderate in protein, with fiber that is less effective than long hay or haylage. Most rations pair it with some alfalfa or grass forage for long fiber, and a protein source to cover what the corn silage lacks. How much corn silage is right depends on the herd and the other feeds, so this is a conversation with your nutritionist, not a number to copy from a neighbor. Ask about particle size, since chopped too fine, corn silage can push rumen pH down.
Mix and deliver it right
Load the mixer in the order your nutritionist recommends, and don't overmix. Over-processing a TMR grinds up the fiber you worked to preserve. Use a particle separator to check what's actually in the bunk, and look at the bunk after feeding for sorting. Push feed up often and clear refusals daily. The National Dairy Council-style resources at usdairy.com cover industry practice, but your own bunk is the best teacher.
Check the quality of what went in
Silage quality is set at harvest: chop length, kernel processing, moisture at chopping and packing density. If your kernels come through whole, they pass through the cow undigested. See our related pieces on testing starch and on processing methods. A forage analysis from a certified lab, including starch, NDF and fermentation profile, tells you what you're really feeding.
A short feeding checklist
- Clean, even face every day.
- Weekly dry matter checks, plus after rain.
- Kernel processing check at harvest and at feeding.
- Particle size check in the bunk.
- Refusals weighed and recorded.
Corn silage doesn't need fancy treatment. It needs the same boring good habits every day, and cows reward that with steady milk.