What is the best way to feed haylage?

Keep it fresh, even, and weighed

ROCHESTER, Minnesota — The best way to feed haylage is to keep the face clean, test the dry matter often, mix it evenly into the TMR, and watch for spoilage that cuts intake. Haylage is wilted, chopped and fermented forage, usually alfalfa, grass or a mix. It's valuable to dairy rations for protein and fiber, but it's wetter than hay and sensitive to air and weather, so what you feed today may not match what you fed last week.

Know what kind of forage you have

Haylage in a bunker, bag or tower can vary a great deal in moisture, fermentation and fiber. Take a representative sample, send it to a lab and ask for dry matter, crude protein, fiber, ash, pH and a fermentation profile. A high ash value can mean soil contamination at harvest, and a poor fermentation profile can mean butyric acid problems that hurt intake. Your nutritionist will use these numbers to set inclusion rates. Wisconsin dairy extension has quality guidance for haylage and forage testing.

Keep the face tight

Like all silage, haylage spoils when air penetrates. Take off a clean slice every day, don't leave loose material piled at the bottom, and keep covers tight until you open the pile. Haylage in bags should be fed out promptly once opened, since smaller faces mean quicker exposure. If you only feed a few cows per day from a big bunker, think about whether you're losing more than you realize. Weigh feed in and out for a month and see.

Watch moisture in the ration

Wetter haylage means a wetter TMR, which can reduce dry matter intake and cause sorting. Dry matter swings after rain, so check more often at harvest and in wet seasons. If haylage dry matter changes by a few points and you don't correct the mixer sheet, cows get less forage than you intended. A forced-air oven or microwave test takes ten minutes and is worth building into the weekly routine.

Mixing and particle length

Haylage is generally long enough to supply effective fiber, but chopped too long, it tangles and sorts; too short and it adds little chewing. Use a particle separator on the delivered TMR. Load haylage early in the mixing order if it is long, so the mixer can break it evenly, and avoid over-mixing. Your nutritionist can recommend the order for your mixer type. Penn State Extension has articles on TMR particle size.

Mind the animal side

Look at refusals daily. Increased refusals and cows sorting can mean poor fermentation, moisture swings or too much long fiber. If cows quit eating haylage that looked fine before, check for heating and mold. Some mold toxins affect fertility and health, and a veterinarian can advise on testing. Don't feed obviously spoiled haylage to hungry cows just to save it.

A quick routine

  1. Sample each new bunker face or bag and send it in.
  2. Check dry matter weekly.
  3. Clean the face every day.
  4. Run the particle separator on the bunk.
  5. Record refusals and compare with milk.

Haylage rewards farmers who pay attention. Weigh it, test it, and don't get sentimental about a pile that's gone bad.