What is the best way to feed silage?
Fresh face, tight feed-out, steady delivery
NEW HOLSTEIN, Wisconsin — The best way to feed silage is to keep the face tight and clean, remove enough every day to outrun heating, mix it into a consistent ration, and keep intake steady. Most silage losses happen at feed-out, not in the pit, and a few minutes of face management saves a surprising amount of feed. Feed it so that it's still fresh when it reaches the cow, not warm and sour.
Manage the face
Take silage from the face in a smooth, vertical cut, using a facer or defacer rather than pulling feed down in chunks that loosen the surface. A loose face lets air in, which feeds yeast and mold, causing heating and losses. Don't leave a ragged face overnight if you can avoid it. Keep the cover on until you need to open it, and remove only what you'll feed soon.
How fast you move through the face matters. A face that's too wide for the herd's daily use tends to heat. Match your bunker or pile width to your feeding rate, and think about this when you build or pack.
Sample and test as you go
Silage changes down the face and over time. Send samples to the lab regularly, not just at the start. Dry matter, starch, fermentation and fiber results guide ration changes. Notice any smell of heated or spoiled feed and discard spoiled silage, which can cause off-feed and, in some cases, health problems.
Feed it in the right mix
Silage works best as part of a TMR with proper particle size and mixing. Don't dump it unmixed at the bunk, since cows will pick the best parts. Check moisture: very wet silage can reduce intake. Keep an eye on corn silage kernel processing, and mix the silage with other forages to balance the ration.
Control heating at the bunk
On hot days, feed fresh more often and clear refusals. Heated silage in the bunk loses palatability. Preservatives or stabilizers designed for aerobic stability can help some herds in warm weather, but check the evidence on the product before buying, and don't treat them as a replacement for good feed-out rates.
Safety around silage
Silage work is risky. Never stand below an overhanging face, and keep people and children away from bunker walls and pile edges. Gases from fresh silage can be dangerous in and around silos. The OSHA agriculture page and the NIOSH agriculture program offer safety resources, and AgriSafe is a helpful reference for farm health and safety.
Know where to learn more
University of Wisconsin Extension, Penn State Extension and the Iowa State Ag Decision Maker all publish silage management guidance, from packing to feed-out. Ask your local extension office about workshops before harvest, since the work you do in the first weeks sets the loss figure for the whole year.
Review each season
At the end of the feeding season, look at how much feed you lost to spoilage and where it happened. Next year, adjust pack density, covering, face width and daily removal. The savings accumulate. Silage is cheap to make and expensive to waste.