What is the best way to mix a TMR?
Load order and mix time matter
ELKHORN, Wisconsin — A total mixed ration only works if every bite looks like the formulation. The best way to mix one is to follow a consistent load order, keep an eye on mixing time, and watch the physical result. The right sequence depends on whether you run a vertical or horizontal mixer, and on how long and wet your forages are. Your nutritionist will give you a recipe, but you control how it's loaded and how long it spins.
Know your mixer type
Vertical mixers use one or more upright augers and tend to chop long forage as they mix. Horizontal mixers use paddles or augers along a horizontal axis and are gentler on length. Reel-style and other designs also exist. The manufacturer's manual is the starting point for fill level, speed and sequence. Don't load past the stated capacity, because overfilling is a common cause of poor mixing. Underfilling can also leave ingredients riding around instead of blending.
Pick a loading order and stay with it
A common approach is to load dry or long forages first in a vertical mixer so the augers can cut them, then grains and supplements, then wet feeds, and liquids last. Horizontal mixers often take the opposite approach, loading long hay in when the other feeds are partly in. The specifics differ by machine. Write the order down, tape it near the controls, and keep it the same each time, so a different operator doesn't change your ration. Add minerals and small-inclusion ingredients where they will be well distributed, not on top of the pile at the end.
Time the mix
Mixing time usually starts once the last ingredient is in. Too short and you get pockets. Too long and the forage is ground down to fines, cutting effective fiber. Many nutritionists suggest a few minutes after the last ingredient, but your own measurements decide. Test with the Penn State Particle Separator at different times to see what happens to the fraction on the top screens. Penn State Extension publishes guidance on how to use it.
Check the result, not just the recipe
A few checks tell you whether the mix is uniform:
- Take samples from the start, middle and end of the bunk and compare particle size.
- Look at the bunk for clumps of grain or concentrated minerals.
- Compare refusals with fresh feed for sorting.
- Ask your nutritionist about a mixer evaluation, which tests uniformity.
Keep knives sharp and replace worn augers, since both change the final particle length.
Keep scales and records straight
Accuracy matters when the formulation is expensive. Calibrate the scale, use the same loading units each time, and record loads. Track how much was loaded versus the recipe. If a load of corn silage is wetter than the last, update the batch weight. A consistent mixer operator pays for himself. Sloppy batches show up in milk and manure.
Small details that add up
Don't mix on a slope if the scale reads the wagon tilted. Keep a clean mixer, since old feed left behind spoils fresh batches. Keep the ration moisture where it needs to be so feed sticks together rather than separating. If you are unsure, ask a university dairy specialist through UW Extension farms or eXtension. A mixer is a big investment, so it deserves a written procedure. Cows don't read labels, but they do notice when dinner changes.