Which milking routine reduces mastitis?
Clean, dry, same every time
NEW HOLSTEIN, Wisconsin — A good milking routine prepares teats gently, removes dirt and bacteria, stimulates letdown, and attaches the unit within a tight time window. The steps are simple, but consistency is what pays. Every cow gets the same treatment, every milking, whoever's in the pit.
The basic steps
A widely taught routine goes like this:
- Wear clean gloves.
- Predip the teats with an approved germicidal dip and let it stay on for the contact time on the label.
- Strip foremilk (a few squirts) to check for clinical mastitis and stimulate letdown.
- Wipe each teat with a clean, dry individual towel.
- Attach the unit after the right prep time.
- After milking, remove the unit smoothly and apply a postdip.
Details vary by herd, bacteria and facilities, so ask your vet or milk quality adviser to fine-tune it. The National Mastitis Council publishes its recommended milking procedures.
Timing and letdown
Cows let down milk in response to teat stimulation. The right prep time lets oxytocin do its work so the unit goes on when the udder is ready. Attaching too early or too late means slow milking, over-milking, and teat-end damage. Aim for a steady and consistent interval between first touch and unit attachment.
Train the crew to work in groups of cows at a rate that keeps the timing right. Rushing to hit a cow count is a common source of problems.
Teat dips
Use products labeled for dairy teat disinfection. Check the label for contact time, dilution, storage and whether it's meant for pre- or postdipping. Keep dip cups clean and refresh the dip. Don't dilute or mix products without guidance. In freezing weather, ask your supplier about winter-ready postdips.
Check coverage: dip at least the lower two-thirds of the teat. Teats should be fully covered, and it's worth auditing now and then.
Towels, gloves and cleanliness
Use a clean towel for each cow, and wash towels with proper detergent and hot water, not too much bleach, and dry them thoroughly. Gloves protect both people and cows, and should be rinsed or changed as needed. Keep the parlor clean and the cows' udders reasonably clean before they enter.
If udders are dirty, fix the cause: bedding, stall design, alleys, or the holding pen. Prep can't make up for cows living in muck.
Equipment and teat ends
Milking equipment that isn't working right will undo even a good routine. Have the system tested at least yearly by a qualified technician. Look for liner wear, vacuum fluctuations and pulsation problems. Check teat ends for redness, cracks and rings, which show if the machine is hurting the cow.
Check for unit slips and falling units, and watch how the crew removes units. Teat-end condition scoring helps you see problems before somatic cell counts climb.
Watch the results
Track bulk tank SCC, cow SCC, clinical cases and new infection rates, and review them when you change anything. Observe milkings regularly, since habits drift. Ask a vet or a neutral observer to watch a milking and write down what they see, in particular the time from first touch to unit-on.
Write the routine down, train new hands and retrain veterans. Whatever you pick, doing it the same way every time beats a perfect routine done randomly.