Which pumps suit manure handling?
Match the pump to the manure
LANCASTER, Pennsylvania — The right manure pump depends on how thick the manure is, how far it has to move, and whether you're agitating a storage or loading a tanker. Chopper pumps, centrifugal pumps, piston pumps, and progressive cavity pumps each handle certain jobs well and others badly. Picking one without knowing your solids content is like buying boots without knowing your size.
Start with the manure itself. Flushed or scrape-diluted manure with low solids behaves almost like water. Scraped manure with bedding can be thick enough to hold a boot print. The pump has to be built for the consistency you actually have, not the one in the brochure.
Know your solids and abrasives
Get a sample tested or ask your extension office how to estimate dry matter. Sand-bedded barns create a very different problem than straw or sawdust barns, because sand is abrasive and wears impellers, liners and seals quickly. Long fibers from straw or corn stalks wrap around impellers and clog. Ask each pump seller what solids range the pump is rated for, and what the wear parts cost and how often they're replaced.
Write down distance and lift too. Pumping uphill or through long pipe adds friction and demands more pressure than the same flow on flat ground.
Common pump types and where they fit
- Chopper pumps cut fibers as they pump, which helps with bedding and stringy material. They're common for transfer and loading from pits.
- Centrifugal pumps move high volumes of thinner manure and are widely used for agitation and loading.
- Piston or positive displacement pumps push thick manure long distances at high pressure, with slower flow.
- Progressive cavity pumps handle thick material with steady metering, useful for feeding separators or digesters, though stators wear.
- Submersible pumps drop into the pit and avoid priming problems but can be harder to service.
Each has trade-offs in price, wear and power draw, so talk with a dealer who services manure systems near you.
Agitation is half the job
A pump can only move what reaches its intake. Settled solids in a lagoon or pit need agitation before pumping, and the agitation method matters: propeller agitators, pump-driven mixing nozzles, or tractor-driven units. Agitating a covered or indoor pit can release dangerous gases, including hydrogen sulfide, which can kill within minutes at high concentrations. Move people and animals out, ventilate, and follow the guidance from NIOSH agriculture on confined spaces and manure gas.
Power, piping and layout
Check that your tractor or electric supply can handle the pump. PTO horsepower, electric service, and the lengths and diameters of your pipe all change how it performs. Undersized pipe makes any pump look bad. Put in valves and clean-outs so a clogged line can be cleared without wrestling with it in the mud, and consider where a break would send manure. Flexible hose for field application should be rated for the pressure.
Rules and records
Nutrient management plans, setbacks and application rules vary by state and by farm size. Check with your state agriculture department and your local NRCS office through NRCS about storage standards and cost-share that may apply to manure handling structures and equipment.
Before you buy, ask for references from a farm with a similar manure type and demand a clear wear-parts price list. If possible, run a demo pump on your own manure first. Keep a spare seal kit and the gear to pull the pump out quickly, because pumps seem to fail on the day the pit is full and the forecast shows rain.