How do I inspect a used grain cart?

What to look at before you buy

SIDNEY, Nebraska — A grain cart takes a beating at harvest. It carries heavy loads over rough ground, and the stress shows up in the frame, the auger, the axle, and the tires. A good inspection before you buy can reveal expensive problems, and it costs you only an hour or two and a flashlight. Bring a helper who can run the cart while you watch and listen.

Frame, tank, and welds

Walk around the cart and look at the hopper walls for dents and patches. Check the frame, tongue, and the axle mounts for cracks and old weld repairs, especially at stress points. Look inside the tank for corrosion, worn spots, and loose hardware. Check the ladder, the platform, and any lids. A repaired frame isn't automatically bad, but ask how it was fixed and why.

The auger system

The auger is the heart of a grain cart. Inspect the flighting for wear, bends, and gaps from the tube. Check the lower and upper bearings and the gearbox for leaks and play. Look at the spout and its controls. Run it empty first, then, if possible, with some grain. Listen for grinding and watch for vibration. Worn flighting lowers unloading speed and can be costly to replace.

Running gear and weight

Check tires for cracks, uneven wear, and proper inflation. Inspect axles, hubs, and wheel bearings for play. Look at the tracks, if equipped, for wear and tension. Check the brakes, lights, and hitch. A grain cart can weigh a lot when loaded, so confirm your tractor can handle it and that your tires, brakes, and hitch are rated accordingly.

Scale and electronics

Many carts have scales, cameras, and monitors. Ask if the scale is calibrated and whether it's accurate. Check cables, load cells, and display. Make sure the electronics work with your tractor. Ask the seller how recently it was calibrated.

PTO and safety

Check the PTO shaft and shields, and look for damaged guards or exposed rotating parts. Inspect the auger covers and safety decals. Grain handling is dangerous; see OSHA's agriculture page and the Great Plains Center for Agricultural Health for guidance on equipment and grain safety.

Ask about history

Compare and decide

Think about capacity and fit

Match the cart to your combine and tractor. Grain carts come in a range of capacities, and the right size depends on your combine's unloading rate, your field size, and your tractor's power. A cart that's too big strains the tractor and compacts soil, while one that's too small slows harvest. Ask other operators how their carts perform with similar combines. Ask the seller what tractor pulled it and what size combine it served.

Look at soil impact

Heavy carts can cause compaction, especially in wet conditions. Check the tire size and type or the track system, and ask about inflation pressure. Wider tires or tracks spread weight over more area. The Natural Resources Conservation Service has information on soil compaction and its effects. If you farm wet ground, this deserves attention before you buy a cart.

Test the unloading on a slope

If you can, watch the cart unload on uneven ground, and on a hillside if your fields are hilly. A cart that tips or shifts while unloading is a hazard. Check the tongue weight and the hitch pin. Watch how the auger folds and unfolds, and whether it clears the combine's unloading spout comfortably. Cart operators should also watch for overhead power lines.

Compare the cart against others in similar condition, and add the cost of any needed repairs. Prices vary by region and season, so use written quotes. Iowa State Ag Decision Maker and farmdoc daily offer machinery cost and replacement guidance.