What are common bearing failure signs?

Listen, feel, and look early

LUBBOCK, Texas — The most common signs of a failing bearing are noise, heat, play and leaking grease, usually showing up in that order of ease to spot. If you walk your equipment before every season and every shift, you'll catch most failures while they're still a cheap fix instead of a field breakdown with a hot shaft and a tow bill.

Noise that wasn't there last week

A healthy bearing hums or is nearly silent. Listen for grinding, rumbling, squealing or a rhythmic clicking that speeds up with ground speed or shaft rpm. A bearing that's starting to fail often makes noise at a certain speed, then goes quiet, then gets louder. Don't trust the quiet part. A long screwdriver or a mechanic's stethoscope held against the housing, with the machine running and guards safely in place, can help you find which bearing is making the sound. Never reach near moving parts; if you can't isolate it safely, shut down and have a shop do it.

Heat you can measure

Bearings run warm, but a housing that's much hotter than the one beside it is a warning. An infrared thermometer is a cheap tool for comparing identical bearings on the same machine after a run. Look for one that's clearly hotter than its twin. Heat points to too little grease, too much grease, contamination or a bearing starting to bind. Don't rely on a hand test on a housing that could be hot enough to burn; use the thermometer.

Play, wobble and looseness

With the machine shut off, locked out and blocked as appropriate, check the shaft or wheel by hand. Feel for side-to-side or up-and-down movement beyond what the manual allows, and listen for notchy rolling when you turn it. Wheel hubs, idler pulleys, PTO shafts, and baler or combine drive shafts are good places to check. Excess play also shows up as uneven belt or chain wear, a wobbling pulley, or a seal that keeps getting pushed out.

Grease and seal clues

Look for grease that has turned dark, gritty or milky, which suggests dirt or water got in. Dry, rusty-looking grease at a fitting can mean the bearing hasn't been serviced. Streaks of grease flung out around a seal, or a seal that is cracked or pushed out of place, point to trouble. Remember that over-greasing can blow seals and run a bearing hot, so follow the manual's interval and amounts rather than pumping until it oozes.

Check the manual and maintenance record

Your operator's manual lists lube points and intervals for each bearing. Keep a simple log of what you greased and when. If a bearing keeps failing in the same spot, ask why: misalignment, a bent shaft, a loose mount or a bad seal upstream may be the real culprit. Extension and ag safety resources such as OSHA's agriculture page cover lockout and guarding practices worth following any time you're working around drivelines.

When to call the shop

If a bearing is noisy, hot and loose at the same time, stop running it. Dealers can often pull a part fast if you give them the model, serial number and the location of the bearing. For help sizing up repair work, ask for a written estimate that lists parts and labor separately. The Tractor Test Lab at Nebraska and your local extension office can also point you to reliable maintenance basics.

Common causes worth knowing

Knowing why bearings fail helps you stop repeat failures. The usual suspects are lack of lubrication, too much grease, dirt and water getting past a damaged seal, misalignment, overloading and simple age. A bearing that fails at the same spot every season usually points to something upstream, like a bent shaft, a belt kept too tight or a mount that's worked loose. When you replace one, look at the shaft surface, the housing and the seal for scoring or wear, and replace those too if they're damaged. A new bearing on a worn shaft won't last long. Ask the shop or parts counter to match the bearing by the number stamped on it or by your machine's parts diagram, and keep the old one to compare. Fresh grease of the type your manual calls for, in the amount it calls for, is cheap insurance.

A bearing is a small, cheap part that likes to fail at the worst possible hour. A ten-minute walk-around before the season starts is about the best deal on the farm.