What are common fuel system problems?
Start with the cheap suspects
GRAND ISLAND, Nebraska — The most common fuel system problems on farm equipment are contaminated or old fuel, clogged filters, water in the tank, air in the lines, failing pumps and dirty injectors or carburetors. Most of them show up as hard starting, loss of power, rough running or stalling under load, and most of them are worth ruling out before blaming the engine.
Dirty, old or watery fuel
Fuel that sits through a season can break down, grow microbial growth or collect water from condensation. Water in a tank is a frequent problem on stored equipment and bulk tanks. Look at a sample from the bottom of the tank or the filter bowl for cloudiness, water or sludge. Keep tanks full when stored, keep bulk tanks clean and covered, and drain water separators on schedule. Ask your fuel supplier about stabilizers and storage guidance for your fuel and equipment.
Clogged filters
A restricted filter starves the engine, especially under heavy load when it needs the most fuel. Symptoms include loss of power at higher rpm, surging and hard starting. Change fuel filters at the intervals in your manual, and sooner after a bad batch of fuel. Use the correct filter for your machine and prime the system according to the manual. Carry spare filters during harvest, since they're cheap and a clog can show up in the middle of a field.
Air in the system
Air can enter through a loose fitting, a cracked line, a bad seal or after a filter change if the system isn't bled properly. Symptoms include hard starting, stalling and rough idle. Follow the bleeding procedure in the manual, check all clamps and lines for leaks and look for wet spots or fuel stains. Never use your hand to feel for high-pressure leaks. Diesel injection pressure can penetrate skin, which is a serious medical emergency.
Pumps, injectors and carburetors
Fuel pumps can wear or fail, causing low pressure and power loss. Injectors can clog or leak, leading to smoke, rough running and poor fuel economy. On gasoline engines, carburetors can gum up from old fuel. Some of these jobs need special tools and training, and a technician with proper diagnostic equipment can save you from replacing parts you didn't need. Ask for a written estimate and the test results that support the diagnosis.
Emissions and electronic controls
Many newer engines use electronic controls and emission systems with sensors, additives and filters that need regular service. Fault codes can point to fuel or sensor problems. Follow the manual for fluids and service intervals, and use the correct additives and fuel grade. Skipping required fluids can trigger derates. Ask your dealer about software updates and recommended service.
Prevention routine
Keep a simple log of filter changes, fuel purchases and tank cleaning. Store fuel in clean, labeled containers or tanks. Check for leaks every season. Dispose of old fuel properly following your state's rules; ask your local environmental or agriculture agency. The EPA site isn't the main source for fuel storage rules, so check with your state agency and your insurer. The OSHA agriculture page covers fire and machinery hazards, and your extension office can offer general guidance.
Cold weather and storage issues
Cold weather adds its own problems. Diesel can gel when temperatures drop, clogging filters and starving the engine. Ask your fuel supplier about winter blends and additives suitable for your climate, and follow the equipment manual on fuel heaters and filter changes. Condensation inside partly empty tanks adds water, so fill tanks at the end of the day and before storage. For equipment that sits, drain or treat fuel following your manual and fuel supplier's guidance, and run it periodically if the manual allows. When you restart a machine after long storage, change filters and check for water before running it hard.
Keep a clean fuel storage routine. Use clean funnels and containers, keep caps on, and check your bulk tank's bottom for sediment occasionally. Most fuel trouble starts when something gets in that shouldn't be there. A little discipline in how you handle fuel saves a lot of hours with a wrench.
When an engine acts up, check the fuel before you tear into the engine. It's the cheapest fix and the one you'll feel silly about missing.
