What should I check on a used planter?

A pre-purchase inspection list

CHAMPAIGN, Illinois — A planter's job is to place seed at a consistent depth and spacing, and any problem it has costs you at harvest, not at purchase. That is why a used planter deserves a careful look. Many problems are cheap to fix, some aren't, and the difference between the two is worth knowing before you shake hands. Bring a flashlight, a notebook, and ideally someone who has run a planter.

The toolbar and frame

Check the toolbar for bends, cracks, and old repairs, especially near the hitch and row-unit mounts. Look at the wing hinges and the hydraulic folding system on folding models. Check the markers, transport wheels, and tires. A planter is long and heavy, so frame problems may affect row spacing and safety on the road.

Row units

Row units are where most wear shows. Check the disc openers for wear, since worn discs change how seed lands. Look at the gauge wheels, closing wheels, seed tubes, and bushings for play and damage. Check the depth adjustment and down-pressure. Worn parts across many rows add up, so count what needs replacing. Look for loose or rusted parts and missing hardware.

The seed meters

Meters are the heart of the planter. Inspect the meter housing, seed discs or fingers, brushes, and seals. Ask when the meters were last tested or rebuilt. A seed meter test stand at a shop or dealer can show singulation and skips. Ask whether the seller used it for corn, soybeans, or both, because meters and discs differ by crop.

Electronics and drives

Modern planters may have electric drives, monitors, sensors, and clutches. Ask whether the monitor works, if sensors are intact, and if the system has been updated. Check wiring for damage and rodent chewing. Ask what it needs from the tractor, such as hydraulic flow and electrical connections. Verify compatibility with your tractor and display. For planter calibration and seed placement basics, see Purdue Extension and CropWatch.

Ask about history

Test and compare

If you can, see it plant, or at least turn it over with the tractor and watch the drives. Get quotes for parts you think it needs, and add those to the price when comparing with other planters. Prices vary with market and region. Check farm financing at Farm Service Agency.

Look at the tractor and the match

A planter needs the right tractor to carry and pull it. Check the hitch category, the horsepower, the hydraulic flow, and the lift capacity, especially for a large folding unit. Count the remotes and confirm the electrical connections. A heavy planter can overload a small tractor's front axle and rear lift. Ask the seller for the weight and specs, and compare them against your tractor's ratings.

Plan for the first test

Before planting day, do a bench check. Hook up the planter, turn the meters, and look at the seed drop. Set a few rows on a clean surface and count seeds. Check the drive chains, the shields, and the markers. Better to find a problem in the shop than in a field with the weather turning. Extension and dealer clinics on planter calibration can teach you what to look for, and many shops offer planter service in the off season.

Get seed and population settings right

Even a good planter can disappoint if the settings are off. Check seed size, plate or disc choice, speed, and down-pressure for each crop and field condition. Ask the seller for the manual or find one online from the maker. Confirm the planting population against your agronomist or extension recommendation. A little attention at setup protects a lot of seed investment.

A planter that looks tired in the shop will look worse in a drought-stressed stand with skips. Pay attention now and enjoy the even rows later.