What should I inspect on a used baler?

A walk-around checklist, front to back

FORT WORTH, Texas — A used baler can look fine standing still and fall apart in the first windrow. Balers have many moving parts that take a beating, and the repair bills can add up fast. A careful inspection, ideally with the machine running, helps you find problems before you own them.

Start with the pickup and feeding system

Look at the pickup tines, tine bars, bearings, cam track and wind guard. Missing or bent tines are a sign of rough use. Check the pickup's floating action and its wheels. Look at the feeding components, including the rotor or stuffer on certain designs, for wear and damage.

Turn the machine by hand if possible, and look for binding or unusual noise. Check the shields and covers.

Inspect the bale chamber

On round balers, look at belts, rollers, chains and bearings. Check belts for cracks, fraying, missing fasteners and worn lacing. Check that the rollers turn freely. On square balers, look at the plunger, knives, bale chamber, tension rails and the needle and knotter system.

Look for bent frames, cracks and repaired welds. Look at the floor and sides for wear, and the gate latches and hydraulics.

A running test shows what a static walkaround cannot. Ask the seller to hook the baler to a tractor, engage the PTO at a low idle and let it run through a few cycles. Watch the pickup turn, the chamber move and the tying system cycle, and listen for knocks, squeals and rattles. If the seller cannot or will not run it, treat that as information and adjust your offer or walk away.

Check the tie or wrap system

Knotters on square balers are complex and unforgiving. Look for worn parts, missing components and signs of poor tying. Ask whether the knotters have been rebuilt. For round balers, check the net wrap or twine system and the cutting mechanism. Ask whether it works reliably.

Run a few bales if possible, and examine the shape, density and tie quality. A baler making uneven or poorly wrapped bales could have more than an adjustment problem.

Take time with documentation. Ask for the manual, the serial number and any maintenance records. Check that the serial number plate is present and matches the paperwork. Ask whether the baler has had major repairs, and whether the seller kept receipts. A machine with a clear history tends to be easier to resell, and you may need that history yourself when you sell it later.

Gearboxes, drive and PTO

Check driveline shields, PTO shafts, shear bolts or slip clutches, chains, sprockets and gearboxes. Look for leaks and play in the bearings. Listen for knocking or whining while it runs.

Grease every fitting that should take grease and see which ones do not accept it. A dry or seized bearing often shows up that way. Ask for any service records.

Hydraulics, electronics and the hitch

Operate every hydraulic function, such as the gate, tailgate, pickup lift and any tension adjustments. Check cylinders and hoses for leaks. If the baler has a monitor, test it and check whether the sensors work. Look at the hitch, jack and tires.

Check the bale count and ask about usage. Bale counts, like hours, give a clue but are not a guarantee. Ask the seller how it was stored and maintained.

Compare and decide

Ask for a written statement of condition and any warranty. Get a dealer or independent technician to inspect it if the investment is large. Compare with similar units from other sellers using current listings, because prices change with season and demand.

For general hay and forage information, see Kansas State Research and Extension and Penn State Extension. For safety, review the NIOSH agriculture page.

A baler that has been kept clean and greased tends to tell you so. If it is caked in old hay and rust, it is telling you something else.