What should I inspect on a used cultivator?

Walk it, tap it, then drive it

LINCOLN, Nebraska — When you look at a used cultivator, you're mostly looking for wear, cracks and bent steel, plus anything that tells you how it was treated. Start at the frame, work toward the ground-engaging parts, then check the hitch, hydraulics and any row-crop guidance gear. Bring a flashlight, a rag, a tape measure and someone who will tell you when you're getting excited about a machine that isn't worth it.

Frame and toolbars

The frame is the part you can't easily fix. Look it over slowly:

Any one of these can be a reason to walk away. A bent main frame is a bad bet for most buyers.

Shanks, sweeps and shovels

These wear out, and replacing them is a normal cost, so you aren't hunting for perfection. You're hunting for surprises.

  1. Count the shanks and check each for bends, cracks or worn mounting holes.
  2. Look at the sweeps or shovels. Thin edges and rounded points mean they're due for replacement.
  3. Check the shank springs or trip mechanisms on spring-trip models. Weak or broken springs show up as shanks sitting at odd angles.
  4. Look for mismatched or odd parts, which can suggest corners were cut.

Ask what parts are still available for this model. Some older cultivators have parts that are hard to find, and that matters more than how clean it looks.

Gauge wheels, hubs and bearings

Lift the machine if you can do so safely, or have the seller raise it, and spin the wheels. Feel for roughness, play and noise. Check tires or wheels for cracks and flat spots. Look at hub seals for grease leaks. Worn bearings are cheap to replace individually but can add up across many wheels, so count them before you negotiate.

Check that depth adjustments work and aren't rusted solid. A depth control that won't move is a problem you'll find out about in the field.

Hitch, hydraulics and extras

Look at the hitch pins and the category match to your tractor. Inspect hydraulic cylinders for pitting on rods and weeping at seals, and examine hoses for cracks and chafing. If it's a folding machine, cycle the folds a few times and watch for leaks or jerky motion. If it has row guidance or other attachments, ask whether they still work.

Also look at the safety side. Missing guards, reflectors and lights are fixable, but note them. The OSHA agriculture page and CDC NIOSH agriculture cover safe machinery handling.

A short field test

If the seller allows it, hitch the cultivator to your own tractor and pull it for a few hundred feet on firm ground. Watch the toolbar from behind. Shanks should track evenly, wings should follow without bouncing, and nothing should rattle loose. Listen for bearing noise and look at the ground behind each shank for a uniform pattern. A shank that digs differently from its neighbors is bent or set wrong. Check for hydraulic leaks after cycling the lift a few times. Even ten minutes of this tells you more than an hour of standing around kicking tires. If the seller refuses any hitch-up at all, bring a trusted mechanic or move on to the next one.

Paperwork and price

Ask the seller how many acres it has covered, what crops, what soils, and where it was stored. Rocky ground and abrasive sand wear steel quickly. Ask for any service records. Then compare with similar machines for sale in your region. farmdoc daily and the Iowa State Ag Decision Maker cover machinery ownership costs and used equipment thinking.

Get the price and any included parts in writing, with the serial number. If the seller won't let you test it in the field or have a mechanic look at it, treat that as information.