What should I inspect on a used roller?
Look at the drum, bearings and frame
TOPEKA, Kansas — On a used roller, the big three are the drum or rolling surface, the bearings and the frame. Add the hitch, hydraulics and tires, and you've covered most of what can go wrong. Whether it's a land roller for seedbeds, a cultipacker, or a ring roller, the same approach applies: look closely, spin it, and ask what it's been through.
The drum or rolling surface
Walk around the whole surface.
- Dents, flat spots and out-of-round sections that will make the roller bounce
- Cracks, especially near end caps and welds
- Thin or worn steel, which you can sometimes judge by tapping and listening or by comparing with the thickness at less-worn spots
- Rust-through, which is a particular problem on water-ballast drums
- Missing or damaged ribs or rings on cultipacker and ring rollers
If it's a water-fillable roller, ask whether it's been stored with water in it through freezing weather. Frozen water can crack a drum. Check the fill plugs and any signs of leaks.
Bearings and axles
Raise the roller if you can do it safely, or have the seller do it, and spin the drum by hand. Feel for roughness, grinding, side-to-side play and wobble. Look for grease leaks around the seals, and check whether the bearings have grease fittings and appear to have been serviced. Worn bearings are a normal repair, but ask how many there are and what they take to replace. Also check the axle ends and mounting plates for wear, elongated holes and cracks.
Frame, hitch and hydraulics
- Check the tongue and hitch for cracks, bends and worn clevis holes.
- Look at the frame sections for weld repairs. Fresh welds need an explanation.
- On folding rollers, cycle the wings and watch for smooth movement. Check hinge pins and bushings for slop.
- Inspect hydraulic cylinders, hoses and fittings for leaks and chafing.
- Check transport locks and safety chains, if equipped.
- Make sure the tires or wheels, if it has transport wheels, hold air and show no dry rot.
Folding rollers are heavy, and a failed fold or lock is a safety problem. Review the OSHA agriculture page and CDC NIOSH agriculture resources on safe equipment handling.
Ask the seller
- How many acres has it covered, and on what soils? Rocky ground beats up a roller.
- Has it been stored inside or out?
- Any repairs, and who did them?
- Why are you selling?
- Can I see it working, or at least pull it a short distance?
Match the roller to your own tractor. Check the width, weight, transport dimensions and hitch type against your needs and your road limits.
Storage and ballast notes
Rollers do their best work when they're properly weighted for the job, so ask the seller how the ballast works and whether it can be adjusted. For water-ballast rollers, drain before freezing weather unless the manual says otherwise, and ask how the seller stored it. Check the drain and fill plugs and their threads. Park the roller where the drum doesn't sit in standing water, because rust starts at the low spot. Look at tire pressures if equipped with transport wheels. A well-stored roller will usually show it in the paint, plugs and bearings, while a neglected one tells its own story in the rust.
Price and paperwork
Compare similar machines listed in your region and look at actual sale results where you can find them. Costs vary by size, type and condition, so don't use a single number as your guide. Get the serial number and price in writing, and check that the seller has the right to sell it. Consider the cost of repairs you've found when you negotiate. For help deciding whether to buy used and how it fits your budget, see farmdoc daily and the Iowa State Ag Decision Maker. If something seems off, a mechanic or fabricator can look at it with you before you pay.
