What should I inspect on a used seeder?

Check the wear before you buy

STILLWATER, Oklahoma — Before buying a used seeder, inspect the metering system, the openers and seed delivery path, the frame and hitch, the drive system and the electronics, then ask for a field test if you can get one. A seeder that looks clean can still hide worn parts that put seeds in the wrong place at the wrong rate, and that costs you yield every acre it runs.

Start with the metering

Metering is where rate accuracy lives. Open the meters or boxes and look for worn, cracked or chipped parts, damaged brushes, gaps in seals and signs of corrosion. Turn the drive by hand if the design allows and see if each meter turns smoothly and consistently. Uneven wear between rows is a flag. Ask whether the unit has been calibrated recently and request any calibration records. Check how the seed or fertilizer sits in the box, since old residue or moisture damage can mean it sat unprotected.

Openers, tubes and depth control

Look at disc openers, boots, closing wheels and press wheels. Discs should be sharp enough, round, and not out-of-true. Check bearings for play. Look at seed tubes for cracks, kinks or plugged sections, and see whether boots are worn through. Depth gauge wheels and their arms should move freely. If the machine uses down-pressure springs or hydraulics, check that they work and aren't leaking. Worn pivot points can throw off depth across a wide toolbar.

Frame, hitch and wings

Walk the whole frame looking for cracks, new weld repairs, bent members and signs of heavy impact. Fresh paint over a repair can be a clue, so look closely. Check hitch pins, wing hinges and fold cylinders and hoses for leaks or wear. Raise and lower the machine and watch for uneven lift. Look at tires and wheel bearings if it transports on its own wheels. A twisted frame leads to poor depth control no matter what else is good.

Drive and electronics

Check drive chains, sprockets, gearboxes and any hydraulic drive motors for wear, noise and leaks. If the seeder has monitors, rate controllers, sensors or section controls, ask for a demonstration with the display powered up and look for error messages. Ask whether the software and hardware are still supported by the maker or by a dealer, since an orphaned monitor can be a headache later. Check wiring harnesses for chewed, cracked or spliced sections.

Ask about history and hours

Ask the seller how many acres it has covered, what crops it planted and whether it ever sat outdoors. Ask for service records, parts receipts and any major repairs. Check the serial number against the manual to confirm the model and year. If buying from a dealer, ask what a pre-sale inspection covered and whether any warranty applies. If it's a private sale, consider paying a shop to look it over before you hand over money. The Kansas State Research and Extension site and your local extension office can help you understand seeding rate and calibration basics.

Do a field or bench test

If possible, run it. Check that every row meters and drops seed, that rates match what the monitor claims and that depth looks consistent. A simple catch-test on the bench, where you collect seed from each outlet over a set number of revolutions, can reveal uneven rows. Dig behind the machine and look at seed placement.

Questions for the seller

Whether it's a dealer or a neighbor, ask a few direct questions before you travel to look. How many acres has it covered, and what seed was run through it, including any treated seed or fertilizer? Has it ever been stored outside? Has anything major been replaced, and when? Why is it being sold? Does it come with the manual and any monitor cables or calibration charts? Ask for photos of the meters and openers taken with the covers off. If the answers are vague, that's a reason to look harder or walk away. A seller who knows the machine and has records is usually a better bet than one who says it ran fine last year and can't say more.

Compare the price to what a replacement of worn parts would cost by getting written quotes for any needed repairs. A used seeder is a good buy when its problems are known and priced in. It's a bad buy when you find them in the field. See Penn State Extension for more on planting and equipment.