What should I know about tractor grease points?

Find them all, and use the right amount

COLUMBIA, Missouri — Grease points, also called zerks or grease fittings, are where a tractor wants its daily attention: pivot pins, joints, bearings and linkage that wear fast if they run dry. The basics are to find every fitting listed in your manual, use the grease it specifies, pump until you see fresh grease and stop, and keep a schedule that matches how hard you work the machine. Skipping it saves five minutes and costs real money later.

Where the fittings are

Your operator's manual has a lubrication chart or diagram. It's the authority for your model. Common spots include:

If you can't find the manual, the dealer's parts department or the manufacturer's website can usually supply one. Walk around the machine with a flashlight and a rag and look for fittings too, since models differ, and a previous owner may have added fittings.

How to do it

  1. Wipe each fitting clean before attaching the gun, so dirt isn't pushed into the joint.
  2. Use the grease type and grade your manual calls for. Don't mix greases without checking compatibility.
  3. Pump slowly until fresh grease just begins to show at the seals, then stop. More isn't better, since too much can blow out seals.
  4. Wipe off the excess, which attracts dust and grit.
  5. Replace any missing or damaged fittings and clear any that are clogged.

A fitting that won't take grease needs attention. Try cleaning it, replacing it, or having a shop check whether the passage is blocked.

How often

Your manual gives hour intervals for each point, often with some points needing daily or every-shift attention and others needing less frequent service. Severe conditions such as dust, mud, water and heavy loader work call for more frequent greasing. Loader and hitch pins on a machine that works all day usually need more than a field tractor on light duty.

Mark your calendar or log hours somewhere visible. Many farmers keep a simple notebook in the cab, and a written record also helps when you sell the machine or file a warranty claim.

What you're looking for while you grease

Greasing is a good time to look for problems. Check for:

Catching play early lets you fix a bushing instead of a bore.

Common mistakes

A few habits cause most grease trouble. Mixing incompatible greases can break down consistency. Using too much grease blows seals and collects dirt. Skipping the loader pins because they're awkward to reach is how pins and bushings wear oval. Using the wrong fitting size or a damaged gun coupler leaves grease on the gun, not the joint. Greasing a hot or running joint is also a bad idea, both for your fingers and for how the grease flows. Keep a spare coupler and a few fittings in your toolbox, and wipe the gun's tip clean after each use.

Tools and safety

A good grease gun, a flexible hose or coupler for tight spots, and spare fittings take care of most jobs. Shut the machine down, lower the loader and implements or lock them, and don't reach into moving parts. The OSHA agriculture page and CDC NIOSH agriculture cover safe maintenance. If a shop does the work, ask what's included in a service. For maintenance costs and scheduling, see farmdoc daily and the Iowa State Ag Decision Maker. The Tractor Test Laboratory can help you look up details on some models.