How do I read a supply and demand table?
From beginning stocks to ending stocks
MANKATO, Minnesota — A supply and demand table, often called a balance sheet, is a simple accounting of where a crop comes from and where it goes. Once you know the rows, you can read the one in USDA's monthly report in about five minutes. The whole thing boils down to one equation: supply minus use equals what's left over.
I won't quote any current numbers. The reports have them, and they change with each release.
The supply side
Supply has three parts.
- Beginning stocks: grain left over from the previous marketing year.
- Production: the crop harvested this year, built from planted area, harvested area and yield.
- Imports: grain brought in from other countries. For some crops this is a small number.
Add them up and you get total supply. If you want to know why production moved from one report to the next, check whether area or yield changed. NASS publishes the crop production data behind it.
The demand side
Use, sometimes called disappearance, includes several categories that vary by crop. For corn you'll see feed and residual, food, seed and industrial uses (which includes ethanol), and exports. For soybeans you'll see crush, exports, seed and residual. Add the categories to get total use.
The "residual" line is a plug number. It captures whatever doesn't fit in measured categories, so treat it as an estimate and not a hard count.
Ending stocks and stocks-to-use
Ending stocks equal total supply minus total use. That's the grain carried into the next marketing year. By itself, it's a number in millions of bushels, which is hard to judge. So analysts divide ending stocks by total use to get stocks-to-use, a percentage that shows how big the cushion is relative to demand.
A low stocks-to-use ratio suggests a tighter market, and a higher one suggests a looser market. Compare the ratio to prior years to judge, and farmdoc daily often writes about how stocks-to-use relates to price.
Marketing year and units
Check the marketing year header. Corn and soybeans, for instance, follow a marketing year that starts around harvest, not the calendar year. Wheat starts earlier. Units differ too: bushels for grains, pounds or bales for other commodities, and metric tons in world tables. Misreading a unit is the easiest mistake in the whole exercise.
Also note whether you're reading the U.S. table or the world table, and whether the number is an estimate, a projection or a final.
How to read changes between reports
- Open the current and previous tables side by side.
- Find which supply or use line changed.
- Check whether ending stocks went up or down as a result.
- Read the report's text, which explains each change in plain language.
USDA's World Agricultural Supply and Demand Estimates, referenced through ERS data products, has these tables with commentary. The AgMRC site and Iowa State Ag Decision Maker offer explanations and examples.
What the table can't tell you
A balance sheet doesn't tell you the price. It gives context for it. It also doesn't tell you where the grain sits. National ending stocks might look comfortable while your region is tight, and basis will show it. Be careful with projections, since they're estimates built on yield and demand assumptions that get revised.
Practice by building one yourself for a crop you grow. Put your own production, feed use and sales into the same layout. It's a good way to spot what you haven't planned for, and it's easier than explaining to the lender where the corn went.
If you want practice, pick last season's report for a crop you grew and fill in your own numbers beside the national ones. Where did your yield land compared with the national figure? How much of your crop went to feed, to sale at harvest, to storage? Doing this once makes the tables feel less abstract. It also shows you how small shifts in a single line, such as a modest change in yield, can move ending stocks a lot more than most people expect, which is exactly why the market pays so much attention to each new estimate.
